A 1 V folded common-gate CMOS low noise amplifier for Wireless Sensor Network applications
Authors:
- 1 November 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
This paper presents a 1 V folded common-gate CMOS low noise amplifier (LNA) for Wireless Sensor Network (WSN) applications. The LNA uses capacitive cross-coupling common- gate (CG) topology to achieve wonderful input matching and low noise figure (NF). A folded topology is employed to reduce the supply voltage and thus power consumption. A source follower acts as the buffer stage for measurement. The LNA is designed in 0.18 μm RF CMOS technology. For saving the chip area, a differential inductor has been designed, which has high inductance value with a small area. With a 1 V power supply, at 2.44 GHz, the post simulation exhibits a high voltage gain of 15.4 dB, and a low voltage gain of 0 dB, with the input impedance of mixer as the load impedance. At high-gain mode, power gain with S21 is 10.5 dB and NF is 3.8 dB. At low-gain mode, S 21 is -6.4 dB and NF is 7.8 dB. Moreover, IPldB is -19 dBm and 1.4 dBm, at the two modes respectively. The LNA core consumes current about 2.35 mA. The total chip area is 1200 μm×580 μm.Keywords
This publication has 7 references indexed in Scilit:
- Design of a fully differential CMOS LNA for 3.1–10.6 GHz UWB communication systemsThe Journal of China Universities of Posts and Telecommunications, 2008
- New matching methodology of low-noise amplifier with ESD protection2006
- G/sub m/-boosted common-gate LNA and differential colpitts VCO/QVCO in 0.18-/spl mu/m CMOSIEEE Journal of Solid-State Circuits, 2005
- A 24-GHz CMOS Front-EndIEEE Journal of Solid-State Circuits, 2004
- Gain and frequency controllable sub-1 V 5.8 GHz CMOS LNA2003
- Sensor networks: an overviewIEEE Potentials, 2003
- A 4.5-mW 900-MHz CMOS receiver for wireless pagingIEEE Journal of Solid-State Circuits, 2000