Comparing Microfluidic Performance of Three-Dimensional (3D) Printing Platforms
Top Cited Papers
Open Access
- 24 March 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 89 (7) , 3858-3866
Abstract
Three-dimensional (3D) printing has emerged as a potential revolutionary technology for the fabrication of microfluidic devices. A direct experimental comparison of the three 3D printing technologies dominating microfluidics was conducted using a Y-junction microfluidic device, the design of which was optimized for each printer: fused deposition molding (FDM), Polyjet, and digital light processing stereolithography (DLP-SLA). Printer performance was evaluated in terms of feature size, accuracy, and suitability for mass manufacturing; laminar flow was studied to assess their suitability for microfluidics. FDM was suitable for microfabrication with minimum features of 321 ± 5 μm, and rough surfaces of 10.97 μm. Microfluidic devices >500 μm, rapid mixing (71% ± 12% after 5 mm, 100 μL/min) was observed, indicating a strength in fabricating micromixers. Polyjet fabricated channels with a minimum size of 205 ± 13 μm, and a surface roughness of 0.99 μm. Compared with FDM, mixing decreased (27% ± 10%), but Polyjet printing is more suited for microfluidic applications where flow splitting is not required, such as cell culture or droplet generators. DLP-SLA fabricated a minimum channel size of 154 ± 10 μm, and 94 ± 7 μm for positive structures such as soft lithography templates, with a roughness of 0.35 μm. These results, in addition to low mixing (8% ± 1%), showed suitability for microfabrication, and microfluidic applications requiring precise control of flow. Through further discussion of the capabilities (and limitations) of these printers, we intend to provide guidance toward the selection of the 3D printing technology most suitable for specific microfluidic applications.Keywords
Funding Information
- Australian Research Council (CE140100012, FT130100101)
This publication has 31 references indexed in Scilit:
- 3D printed microfluidic devices: enablers and barriersLab on a Chip, 2016
- Pressure-actuated microfluidic devices for electrophoretic separation of pre-term birth biomarkersAnalytical and Bioanalytical Chemistry, 2015
- 3D printed microfluidic devices with integrated valvesBiomicrofluidics, 2015
- Cost-Effective Three-Dimensional Printing of Visibly Transparent Microchips within MinutesAnalytical Chemistry, 2014
- A review on 3D micro-additive manufacturing technologiesThe International Journal of Advanced Manufacturing Technology, 2012
- Integrated 3D-printed reactionware for chemical synthesis and analysisNature Chemistry, 2012
- When PDMS isn't the best2007
- Prototyping of Microfluidic Devices in Poly(dimethylsiloxane) Using Solid-Object PrintingAnalytical Chemistry, 2002
- A comparison of rapid prototyping technologiesInternational Journal of Machine Tools and Manufacture, 1998
- NavelbineDrugs of the Future, 1986