Effect of the core‐shell impact modifier shell thickness on toughening PVC
Authors:
- 19 October 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (10) , 1885-1889
Abstract
The shell thickness of a core/shell impact modifier is found to be the single most important factor in the toughening of rigid polyvinyl chloride (PVC). When the shell thickness is greater than a critical value of 15.8 nm, these core‐shell elastomeric particles are able to remain structurally intact and well dispersed within the PVC matrix after melt blending. However, too thick a shell thickness results in a hard core (high modulus) of these core/shell particles and loss of the rubbery nature required of an efficient impact modifier. Therefore, these over‐thick particles can act only as rigid fillers, not as efficient rubbery modifiers. On the other hand, when the shell thickness is less than the critical value of 4.9 nm, too thin a shell layer is simply unable to fully protect and cover the inner rubbery core during vigorous processing conditions, and these core‐shell particles tend to connect with one another through the partially exposed core to form a cellular‐like structure, thus resulting in poor toughening efficiency. Regardless of the particle size, as long as the shell thickness of these core/shell elastomers is between these two critical values (15.8 nm and 4.9 nm), they all display high efficiency in toughening rigid PVC. Polym. Eng. Sci. 44:1885–1889, 2004. © 2004 Society of Plastics Engineers.Keywords
This publication has 11 references indexed in Scilit:
- Thermal stimulated current study of core‐shell impact modifier/PVC blendsJournal of Vinyl and Additive Technology, 1997
- Impact modifiers: Providing a boost to impact performanceJournal of Vinyl and Additive Technology, 1995
- A novel impact modifier system for vinyl siding and profile substrateJournal of Vinyl and Additive Technology, 1994
- Impact modifiers for PVCJournal of Vinyl and Additive Technology, 1993
- A novel staining technique for studying toughening mechanisms in saturated acrylic rubber‐modified polymersJournal of Polymer Science Part B: Polymer Physics, 1991
- The impact behavior of rigid PVC compoundsPolymer Engineering & Science, 1966
- Stress-whitening in high-impact polystyrenesPolymer, 1965
- Stress—strain behavior of rubber‐reinforced glassy polymersJournal of Applied Polymer Science, 1965
- Short-time stress relaxation and toughness of rubber-modified polystyreneJournal of Applied Polymer Science, 1960
- Studies on heterogeneous polymeric systemsJournal of Polymer Science, 1956