Diffuse-reflection-based single-ended laser absorption sensor for H 2 O temperature and concentration in kerosene-fuelled combustor
- 10 July 2020
- journal article
- research article
- Published by IOP Publishing in Measurement Science and Technology
- Vol. 31 (10) , 105202
Abstract
The design, optimization and demonstration of a compact, single-ended laser absorption sensor based on a diffuse-wall-reflected signal is presented for temperature and H 2 O concentration measurements in a kerosene-fuelled aero-combustor. The challenges of laser measurements in such harsh, practical combustion environments involve strong beam-steering, low signal-to-noise ratio (SNR), and constrained optical access. We present here a detailed characterization and optimization procedure of a single-ended optical configuration using a holed off-axis parabolic mirror as the pitch and catch optics, and the coked wall surface of the combustor as a diffuse reflector. A near-infrared distributed-feedback diode laser near 1.4 µm scanned at 1 kHz for direct absorption detection was used to access two H 2 O transitions for concentration and temperature measurement. An optical system design and adaptive Savitzky–Golay signal processing algorithm were used for noise suppression and SNR amelioration. The sensor was demonstrated under practical conditions in a kerosene-fuelled swirl combustor. High signal fidelity was achieved and allowed for a single-scan H 2 O concentration detection limit of 122 ppm MHz −1/2 , despite a low reflected laser intensity level of ~50 µW. In situ , time-resolved measurements detected temperatures ranging from ~1100 K to 1300 K, and H 2 O concentration ranging from ~8% to 12% as global equivalence ratio varied between 0.2 and 0.45. The results revealed an expected trend while demonstrating much faster response and less delay versus a comparative thermocouple. This successful field manifestation provides direct proof for the robustness and reliability of a diffuse-reflection-based single-ended sensor system in engine combustion chamber environments.Keywords
Funding Information
- National Natural Science Foundation of China (51976105)
- National Science and Technology Major Project (2017-III-0004-0028)
This publication has 33 references indexed in Scilit:
- Development of laser absorption techniques for real-time, in-situ dual-species monitoring (NO/NH3, CO/O2) in combustion exhaustProceedings of the Combustion Institute, 2013
- Wavelength-modulation-spectroscopy for real-time, in situ NO detection in combustion gases with a 5.2 μm quantum-cascade laserApplied Physics B, 2011
- Applications of quantitative laser sensors to kinetics, propulsion and practical energy systemsProceedings of the Combustion Institute, 2011
- In situ absorption sensor for NO in combustion gases with a 5.2μm quantum-cascade laserProceedings of the Combustion Institute, 2011
- Detailed and Reduced Mechanisms of Jet a Combustion at High TemperaturesCombustion Science and Technology, 2008
- Liquid-Fueled Strut-Based Scramjet Combustor Design: A Computational Fluid Dynamics ApproachJournal of Propulsion and Power, 2008
- Measurement of Non-Uniform Temperature Distributions Using Line-of-Sight Absorption SpectroscopyAIAA Journal, 2007
- Experimental investigation of kerosene fuel combustion in supersonic flowJournal of Propulsion and Power, 1995
- Spectrum line profiles: The Voigt functionJournal of Quantitative Spectroscopy and Radiative Transfer, 1967
- Two-dimensional convection from heated wires at low Reynolds numbersJournal of Fluid Mechanics, 1959