A Sensitive Atomic Absorption Spectrometric Method for Copper Employing the Direct Introduction of Chelating Resin into a Carbon Tube Atomizer
Authors:
- 1 May 1981
- journal article
- Published by Oxford University Press (OUP) in Bulletin of the Chemical Society of Japan
- Vol. 54 (5) , 1364-1367
Abstract
A new and simple method for the determination of ppb levels of copper by electrothermal atomic absorption spectrometry was established. The main feature of the proposed method is that chelating resin, a preconcentration agent for copper, is introduced directly as a “resin-suspension” into the carbon tube atomizer without drying and weighing of the resin. To a 250 cm3 sample solution containing up to 1.0 μg of copper, 0.10 g of chelating resin (below 400 mesh) is added, and the mixture is stirred for about 20 min. After the separation of the resin from the aqueous phase through a membrane filter, 5.0 cm3 of resin-suspension is prepared by adding water to the resin. Then, 10 μdm3 (resin: 0.2 mg) of the suspension is introduced into an atomizer, and the copper peak-height is measured under the optimum operating conditions. The calibration graph was linear over the concentration range from 0.1 ppb to 4.0 ppb of copper. The relative standard deviation was 2.3% from 10 repeated measurements; a mean value of 1.08 ppb copper was obtained for a sea water sample.Keywords
This publication has 3 references indexed in Scilit:
- Determination of lead in plastic containers for pharmaceutical products by atomic-absorption spectrophotometry using a carbon rod atomiserThe Analyst, 1978
- The determination of vanadium in sea water by hot graphite atomic absorption spectrometry on chitosan after separation from saltAnalytica Chimica Acta, 1974
- A temperature-controlled graphite tube furnace for the determination of trace metals in solid biological tissueTalanta, 1974