Estimation of Solute Carbon Concentration by Electrical Resistivity Measurement in Martensitic Steel
Authors:
Open Access
- 15 May 2021
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 61 (5) , 1708-1715
Abstract
The electrical resistivity of low-carbon martensitic steels was measured to estimate the carbon concentration in the solid solution. Since electrical resistivity is influenced not only by solute carbon but also by substitutional elements, lattice defects, and second phase, the effects of these factors need to be subtracted from the total electrical resistivity to obtain an accurate solute carbon concentration via this method. Consequently, the effects of dislocations and grain boundaries were much smaller than those of solute elements, representing approximately 1–2% of the total electrical resistivity in martensitic steel. However, substitutional elements and retained austenite were found to be significantly effective. By subtracting these effects from the measured value, the change in electrical resistivity owing to solute carbon (Δρsol.C) could be formulated as a function of the carbon concentration in the solid solution of martensite (Csol) as follows:Δρsol.C[mΩmm] = 0.25 × Csol[mass%]The estimated solute carbon concentration was confirmed to correspond to the directly measured value by atom probe tomography.Keywords
This publication has 14 references indexed in Scilit:
- Quantitative evaluation of Cu particle dissolution in cold-worked ferritic steelScripta Materialia, 2017
- Change in Dislocation Characteristics with Cold Working in Ultralow-carbon Martensitic SteelISIJ International, 2016
- Microstructures and hardness of as-quenched martensites (0.1–0.5%C)Acta Materialia, 2011
- Quantitative measurement of deformation-induced martensite in 304 stainless steel by X-ray diffractionScripta Materialia, 2004
- Calculation of electrical resistivity produced by dislocations and grain boundaries in metalsJournal of Physics: Condensed Matter, 1994
- Aging of ferrous martensitesProgress in Materials Science, 1992
- Spinodal decomposition during aging of Fe-Ni-C martensitesMetallurgical Transactions A, 1989
- Relationship between the Electrical Resistivity and the Volume Fraction of Martensite Induced by Quenching and DeformationJournal of the Japan Institute of Metals and Materials, 1985
- The aging and tempering of iron-nickel-carbon martensitesMetallurgical Transactions A, 1983
- Formation Temperature and Growth Behaviour of Thin Plate Martensite in Fe-Ni-C AlloysJournal of the Japan Institute of Metals and Materials, 1974