Effect of Post-Mixing pH Regulation of a Gelatin–κ-Carrageenan System on the Structure and 3D Printing Performance of Yellow Peach Pulp Gels
Open Access
Abstract
Extrusion-based three-dimensional food printing requires inks that can be smoothly extruded while maintaining sufficient structural stability after deposition. In this study, gelatin and κ-carrageenan were first mixed and then subjected to post-mixing pH regulation before spray drying, producing composite powders with different structural states. These powders were incorporated into yellow peach pulp gels to prepare fruit-based printing inks, and their printing performance, extrusion behavior, mechanical properties, particle-size distribution, and microstructure were systematically evaluated. The results showed that the structural state formed during gelatin–κ-carrageenan powder preparation was closely associated with the extrusion stability and shape retention of the final inks. Among the tested formulations, the ink prepared with gelatin–κ-carrageenan powder pre-regulated to pH 4.0 exhibited the best overall printability. Although its pore-area fidelity was slightly lower than that of the sample pre-regulated to pH 3.5, it produced more stable multilayer cylinders and better-defined lattice structures. In addition, the pH 4.0 sample showed the lowest and most stable extrusion force and the highest Young’s modulus, indicating a favorable balance between extrusion flowability and post-deposition support. Microstructural observations and particle-size analysis suggested that pH regulation altered the aggregation state and local morphology of the gelatin–κ-carrageenan system. Samples prepared at higher pH values tended to form larger and less uniform aggregates, which was unfavorable for stable extrusion and shape retention. Overall, post-mixing pH regulation of gelatin–κ-carrageenan provides a practical strategy for improving the printing-related properties of fruit-based gel inks.Keywords
Funding Information
- Yunnan Fundamental Research Projects (202301AT070359)
- The Science Popularization Project of Yunnan Province (202604AM350040)
- Young talents from Yunnan Province’s “Prosperous Yunnan Talent Support Plan” (XDYC-QNRC-2022-0569)
This publication has 34 references indexed in Scilit:
- Quantitative analysis of 3D food printing layer extrusion accuracy: Contextualizing automated image analysis with human evaluationsCurrent Research in Food Science, 2023
- Extrusion-Based 3D Food Printing: Technological Approaches, Material Characteristics, Printing Stability, and Post-processingFood Engineering Reviews, 2021
- Improvement of 3D printability of buckwheat starch-pectin system via synergistic Ca2+-microwave pretreatmentFood Hydrocolloids, 2021
- Color/aroma changes of 3D-Printed buckwheat dough with yellow flesh peach as triggered by microwave heating of gelatin-gum Arabic complex coacervatesFood Hydrocolloids, 2021
- Modification of heat-induced whey protein gels by basic amino acidsFood Hydrocolloids, 2020
- Macromolecular complexes of lysozyme with kappa carrageenanFood Hydrocolloids, 2018
- Complexation of κ-carrageenan with gelatin in the aqueous phase analysed by 1H NMR kinetics and relaxationCarbohydrate Polymers, 2017
- Microstructure and mechanical properties of arabinoxylan and (1,3;1,4)-β-glucan gels produced by cryo-gelationCarbohydrate Polymers, 2016
- Hydrogen bonding enhances the electrostatic complex coacervation between κ-carrageenan and gelatinColloids and Surfaces A: Physicochemical and Engineering Aspects, 2015
- Hydrocolloids as thickening and gelling agents in food: a critical reviewJournal of Food Science and Technology, 2010