Stability improvement in a gain-clamped L-band erbium-doped fiber amplifier through hybrid gain control
Authors:
- 10 May 2018
- journal article
- research article
- Published by SPIE-Intl Soc Optical Eng in Optical Engineering
- Vol. 57 (05) , 056105-5
Abstract
The stability of gain-clamped erbium-doped fiber amplifiers (EDFAs) may be affected by the parameter drift of active and passive devices. We propose a hybrid gain-control scheme to enhance the working stability, which consists of an optical dual-fiber-Bragg-grating (FBG)-based linear cavity and an electrical fuzzy-based controller. The principle of optical gain clamping is then depicted and a detailed design about dual-channel fuzzy controller is given. The experimental results show that, in the dual-FBG configuration, with 20.2-dB mean gain, the designed L-band EDFA simultaneously guarantees the ±0.1-dB stability (with 30-dB dynamic range) and the ∼0.4-dB flatness in the range of 1570 to 1610 nm. In addition, under the electrical feedback control, the flatness stability of gain spectrum reaches ±0.18 dB within 60 min and the mean gain stability is about ±0.34 dB within 10-h continuous operation.Keywords
Funding Information
- Heilongjiang University
- National Natural Science Foundation of China (61302075)
- National Natural Science Foundation of China (61302075)
- National Natural Science Foundation of China (61675066)
- Natural Science Foundation of Heilongjiang Province (QC2015068)
This publication has 23 references indexed in Scilit:
- Gain-flattened two-stage L-band erbium-doped fiber amplifier by weak gain-clamped techniqueOptical Engineering, 2015
- Refractive Index and Temperature Sensor Based on Double-Pass M–Z Interferometer With an FBGIEEE Photonics Technology Letters, 2014
- Theoretical and experimental study of multifunction C+L band hybrid fiber amplifiersOptics & Laser Technology, 2014
- Dual-stage L-band erbium-doped fiber amplifier with distributed pumping from single pump laserOptics Communications, 2012
- Opto-optical gain-clamped L-band erbium-doped fiber amplifier with C-band control signalApplied Optics, 2009
- The L-band EDFA of high clamped gain and low noise figure implemented using fiber Bragg grating and double-pass methodOptics Communications, 2008
- Gain Clamping in Two-Stage>tex<$L$>/tex<-Band EDFA Using a Broadband FBGIEEE Photonics Technology Letters, 2004
- Gain flattened L-band EDFA based on upgraded C-bandEDFA using forward ASE pumping in an EDF sectionElectronics Letters, 2000
- Design and modeling of laser-controlled erbium-doped fiber amplifiersIEEE Journal of Selected Topics in Quantum Electronics, 1997
- Modeling erbium-doped fiber amplifiersJournal of Lightwave Technology, 1991