A deep‐hole microblasting technique for controlling coal wall spalling during mining of a vertically jointed seam
Authors:
Open Access
- 27 March 2022
- journal article
- research article
- Published by Wiley in Energy Science & Engineering
- Vol. 10 (7) , 2253-2267
Abstract
The vertically‐jointed coal seam, especially after water drainage, is easy to lead to large‐area coal wall spalling (CWS). To alleviate the problem, a strut subjected to equivalent central‐concentrated force was proposed for elaborating critical conditions for coal instability based on CWS characteristics, determining the main control factors. The sensitivity analysis of factors driving CWS revealed that the coal between 3.3 and 4.56 m was the most vulnerable. A microblasting technique was proposed for controlling CWS by increasing the friction coefficient at the weakened‐primary coal interface, improving the coal stress, and reducing the equivalent mining height. The paper presented the application of universal distinct element code models to simulate the CWS mechanism with different joint mechanical parameters and microblasting heights. The reduction of spalling intensity indicates that the microblasting weakening of the upper part coal could improve the overall stability of the coal. LS‐DYNA is employed for simulating the fractures development between blasting holes, and the rationality of optimized blasting parameters is revealed. The fracture characteristics of the observation hole in field demonstrated that the hole was effectively fractured by microblasting. The spalling parameters including depth, width and frequency were obviously reduced, which showed the rationality in microexplosion controlling spalling.Keywords
This publication has 15 references indexed in Scilit:
- Numerical modeling of coal wall spall in a longwall faceInternational Journal of Rock Mechanics and Mining Sciences, 2016
- Numerical simulations of blast loads and structural deformation from near-field explosions in airInternational Journal of Impact Engineering, 2011
- Rock damage control in bedrock blasting excavation for a nuclear power plantInternational Journal of Rock Mechanics and Mining Sciences, 2011
- Different Approaches for Simulating Brittle Failure in Two Hard Rock Mass Cases: A Parametric StudyRock Mechanics and Rock Engineering, 2009
- Determination of the effect of roof pressure on coal hardness and excavation productivity: an example from a Çayırhan lignite mine, Ankara, Central TurkeyInternational Journal of Coal Geology, 2008
- Numerical simulation of tensile damage and blast crater in brittle rock due to underground explosionInternational Journal of Rock Mechanics and Mining Sciences, 2007
- Fracture mechanisms and instability of openings in compressionInternational Journal of Rock Mechanics and Mining Sciences, 2000
- A new constitutive model for blast damageInternational Journal of Rock Mechanics and Mining Sciences, 1996
- Microcrack-induced damage accumulation in brittle rock under dynamic loadingComputer Methods in Applied Mechanics and Engineering, 1986
- Phenomenological model of shock initiation in heterogeneous explosivesThe Physics of Fluids, 1980