Investigation on the Microstructure and Mechanical Properties of 304 Stainless Steel Joints by Underwater Local Dry Laser Welding
Open Access
Abstract
In order to verify the feasibility of in situ repair of underwater local dry laser welding (ULDLW) on nuclear power reactor components, this work investigates the microstructure and mechanical properties of 304L austenitic stainless steel repaired by ULDLW using ER308L filler metal. Comprehensive comparison would be made between the ULDLW and conventional in-air laser welding to evaluate their applicability. The results demonstrate that the rapid cooling rate inherent to the underwater environment significantly influences solidification behavior and microstructural evolution. The weld metal (WM) solidifies in the ferritic–austenitic (FA) mode, with an increased proportion of lathy δ-ferrite at the expense of skeletal morphology compared to the in-air welds. Electron backscatter diffraction (EBSD) analysis reveals the substantial grain refinement in underwater welds, with average grain sizes of 39.4 μm versus 47.3 μm for in-air weld bead, accompanied by a higher fraction of low-angle grain boundaries (LAGBs). These microstructural modifications yield superior mechanical properties: underwater weld bead exhibits ultimate tensile strength (UTS) of 685.6 MPa, elongation of 57.5%, and impact toughness of 22.6 J, significantly exceeding the corresponding values for in-air welds (663.9 MPa, 51.8%, and 18.6 J, respectively). Fractographic analysis confirms ductile fracture mechanisms in both conditions. The enhanced performance is attributed to grain refinement strengthening via the Hall–Petch relationship and the increased LAGBs fraction, which impedes dislocation motion and crack propagation.Keywords
Funding Information
- National Natural Science Foundation of China (52205368)
- Postdoctor Project of Hubei Province (2024HBBHCXB055)
- Wuhan Natural Science Foundation (2024040801020243)
This publication has 33 references indexed in Scilit:
- Underwater welding: Evaluation of the structural characteristics of the fusion zone generated in an A36 structural steel welded by FCAW-SThe International Journal of Advanced Manufacturing Technology, 2025
- Tailoring microstructural evolution in laser deposited nickel-aluminum bronze alloy by controlling water cooling conditionJournal of Materials Processing Technology, 2024
- Machine learning-assisted wire arc additive manufacturing and heat input effect on mechanical and corrosion behaviour of 316 L stainless steelsStructures, 2024
- Cooperative enhancement of strength and corrosion resistance through architecture of nanotwins and low angle grain boundary in Ni20Cr alloyCorrosion Science, 2023
- Insights into the stress corrosion cracking resistance of a selective laser melted 304L stainless steel in high-temperature hydrogenated waterActa Materialia, 2022
- Effect of Grain Refining on Properties of a Cast Superaustenitic Stainless SteelJournal of Materials Engineering and Performance, 2019
- Underwater local dry cavity laser welding of 304 stainless steelJournal of Materials Processing Technology, 2018
- Cooling rate predictions and its correlation with grain characteristics during electron beam welding of stainless steelThe International Journal of Advanced Manufacturing Technology, 2018
- Distinct fatigue cracking modes of grain boundaries with coplanar slip systemsActa Materialia, 2016
- Thick Plate CO2-Laser Based Hybrid Welding of Structural SteelsWelding in the World, 2009