Research on a Novel Heat Treatment Process for Boron Steel Used for Soil-Engaging Components of Tillage Machinery
Open Access
- 8 September 2024
- journal article
- research article
- Published by MDPI AG in Agriculture
- Vol. 14 (9) , 1555
Abstract
To address the issue of high fracture and wear failure rates caused by the lack of toughness and abrasion resistance in the steel used for soil-engaging components of tillage machinery, a novel composite heat treatment process, “normalizing and intercritical quenching and tempering (NIQT)”, is proposed. By regulating the austenitizing heating temperature in the intercritical area (ferrite/austenite two-phase area), the type, content, and distribution of phases in the 27MnCrB5 test sample could be precisely controlled, which further influenced the mechanical properties of the material. The results demonstrated that a multiphase composite microstructure, predominantly consisting of martensite and ferrite, could be obtained in the 27MnCrB5 steel treated by the NIQT process. The results of an EBSD test indicated that the predominant type of grain boundary following the NIQT heat treatment was a high-angle grain boundary (approximately 59.5%), which was favorable for hindering crack propagation and improving the impact toughness of the material. The results of the mechanical tests revealed that, when the quenching temperature was set to 790 °C, the 27MnCrB5 steel attained excellent comprehensive mechanical properties, with a tensile strength of 1654 MPa, elongation of 10.4%, impact energy of 77 J, and hardness of 530 HV30. Compared with conventional heat treatment processes for soil-engaging components, this novel process has the potential to enhance the performance of soil-engaging components and prolong their service life.Keywords
Funding Information
- National Natural Science Foundation of China (52175410, NGXB20240106)
- Project of Faculty of Agricultural Engineering of Jiangsu University (52175410, NGXB20240106)
This publication has 28 references indexed in Scilit:
- Impacts of soil microplastics on crops: A reviewApplied Soil Ecology, 2022
- Study on the wear and corrosion resistance of Fe–Mo coatings on 65Mn steel ploughshares by laser claddingApplied Physics A, 2022
- Selecting the proper material for a grain loss sensor based on DEM simulation and structure optimization to improve monitoring abilityPrecision Agriculture, 2020
- Wear behavior of carbonitride-treated ploughshares produced from 30MnB5 steel for soil tillage applicationsMetal Science and Heat Treatment, 2011
- Microstructures and hardness of as-quenched martensites (0.1–0.5%C)Acta Materialia, 2011
- Grain boundary influence on short fatigue crack growth rateInternational Journal of Fracture, 2010
- Grain boundary engineering for superplasticity in steelsJournal of Materials Science, 2005
- Study of the influence of deformation and thermal treatment on the ultrasonic behaviour of steelJournal of Materials Processing Technology, 1994
- The boron hardenability effect in thermomechanically processed, direct-quenched 0.2 Pct C steelsMetallurgical Transactions A, 1990
- Influence of boron on the decomposition of austenite in low carbon alloyed steelsMetallurgical Transactions A, 1975