Analysis of the effect of selected factors on the strength of adhesive joints
Author:
Open Access
- 10 August 2018
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 393 (1) , 012041
Abstract
Adhesive joining is one of the well-established methods for joining structural materials, however it was not until the rapid development in chemistry of adhesives that it could gain wide recognition. It is impossible to imagine any branch of modern industry without adhesive joining technology, which proves indispensible in: aircraft, aerospace, automotive or building industries. The importance of adhesive joining and adhesive materials in the economy of modern world is unparalleled. Among the factors of crucial importance to the strength of adhesive joining it is the preparation of adhered surfaces through proper treatment that appears to predominate. The issue is even more important as the decision regarding the surface treatment is undertaken by a technologist, whereas the other elements of joining technology, such as temperature, time or load applied during cure, and the joint seasoning time are known and specified by manufacturers for each adhesive. Another factor relevant to the strength of adhesive joints is the effect of cyclic thermal loading. The disparity in the coefficient of thermal expansion of adhesives and adherends and in their thermal conductivity results in the adhesive joint being subjected to cyclic internal stresses. Thermal fatigue of cured adhesives may implicate ageing processes, increase polydispersity of the substrate and consequently affect its mechanical properties. This paper presents the results of comparative analysis of the shear strength of adhesive lap joints. The tests were performed on samples following different surface treatment methods, which were subsequently subjected to thermal shock in the varying range of temperatures between -40 °C and +60 °C.Keywords
This publication has 8 references indexed in Scilit:
- Prototyping of Cosmetic Prosthesis of Upper Limb Using Additive Manufacturing TechnologiesAdvances in Science and Technology Research Journal, 2017
- Experimental Study on the Riveted Joints in Glass Fibre Reinforced Plastics (GFRP)Archive of Mechanical Engineering, 2017
- INFLUENCE OF POST-PROCESSING ON ACCURACY OF FDM PRODUCTSAdvances in Science and Technology Research Journal, 2017
- INFLUENCE OF REPAINTING ON THE MECHANICAL PROPERTIES, SURFACE TOPOGRAPHY AND MICROSTRUCTURE OF POLYESTER POWDER COATINGSAdvances in Science and Technology Research Journal, 2017
- COMPARATIVE ANALYSIS OF EFFECT OF THERMAL SHOCK ON ADHESIVE JOINT STRENGTHAdvances in Science and Technology Research Journal, 2016
- Polyamide 6 surface layer following ozone treatmentInternational Journal of Adhesion and Adhesives, 2016
- IMPACT OF THERMAL FATIGUE ON YOUNG’S MODULUS OF EPOXY ADHESIVESAdvances in Science and Technology Research Journal, 2015
- Surface topography effect on strength of lap adhesive joints after mechanical pre-treatmentArchives of Civil and Mechanical Engineering, 2013