Voltage mode electronically tunable full-wave rectifier
Open Access
- 1 January 2017
- journal article
- research article
- Published by Walter de Gruyter GmbH in Journal of Electrical Engineering
- Vol. 68 (1) , 61-67
Abstract
The paper presents a new realization of bipolar full-wave rectifier of input sinusoidal signals, employing one MO-CCCII (multiple output current controlled current conveyor), a zero-crossing detector (ZCD), and one resistor connected to fixed potential. The circuit provides the operating frequency up to 10 MHz with increased linearity and precision in processing of input voltage signal, with a very low harmonic distortion. The errors related to the signal processing and errors bound were investigated and provided in the paper. The PSpice simulations are depicted and agree well with the theoretical anticipation. The maximum power consumption of the converter is approximately 2.83 mW, at ±1.2 V supply voltages.Keywords
This publication has 18 references indexed in Scilit:
- A new tunable current-mode peak detectorMicroelectronics Journal, 2014
- A Sub-500 mV Highly Efficient Active Rectifier for Energy Harvesting ApplicationsIEEE Transactions on Circuits and Systems I: Regular Papers, 2011
- A new full-wave rectifier circuit employing single dual-X current conveyorInternational Journal of Electronics, 2008
- A Broadband CMOS Amplitude Detector for On-Chip RF MeasurementsIEEE Transactions on Instrumentation and Measurement, 2008
- CURRENT CONTROLLED PRECISION RECTIFIER CIRCUITSJournal of Circuits, Systems and Computers, 2007
- Full-wave rectifier realization using only two CCII+s and NMOS transistorsInternational Journal of Electronics, 2006
- A high-performance full-wave rectifier circuitInternational Journal of Electronics, 2000
- Current-mode precision rectificationInternational Journal of Electronics, 1995
- Current controlled bandpass filterbased on translinear conveyorsElectronics Letters, 1995
- Current-mode rectifier with improved precisionElectronics Letters, 1995