3D Printing of an Aortic Aneurysm to Facilitate Decision Making and Device Selection for Endovascular Aneurysm Repair in Complex Neck Anatomy
Authors:
- Stephen D. LaycockSLStephen D. Laycock
- James R.I. BrownJBJames R.I. Brown
- Matthew JakewaysMJMatthew Jakeways
- 1 December 2013
- journal article
- case report
- Published by International Society of Endovascular Specialists in Journal of Endovascular Therapy
- Vol. 20 (6) , 863-867
Abstract
To describe rapid prototyping or 3-dimensional (3D) printing of aneurysms with complex neck anatomy to facilitate endovascular aneurysm repair (EVAR). A 75-year-old man had a 6.6-cm infrarenal aortic aneurysm that appeared on computed tomographic angiography to have a sharp neck angulation of ~90°. However, although the computed tomography (CT) data were analyzed using centerline of flow, the true neck length and relations of the ostial origins were difficult to determine. No multidisciplinary consensus could be reached as to which stent-graft to use owing to these borderline features of the neck anatomy. Based on past experience with rapid prototyping technology, a decision was taken to print a model of the aneurysm to aid in visualization of the neck anatomy. The CT data were segmented, processed, and converted into a stereolithographic format representing the lumen as a 3D volume, from which a full-sized replica was printed within 24 hours. The model demonstrated that the neck was adequate for stent-graft repair using the Aorfix device. Rapid prototyping of aortic aneurysms is feasible and can aid decision making and device delivery. Further work is required to test the value of 3D replicas in planning procedures and their impact on procedure time, radiation dose, and procedure cost.Keywords
This publication has 14 references indexed in Scilit:
- Chimney and Periscope Grafts Observed Over 2 Years After Their Use to Revascularize 169 Renovisceral Branches in 77 Patients With Complex Aortic AneurysmsJournal of Endovascular Therapy, 2013
- Endovascular Aortic Aneurysm Repair with Chimney and Snorkel Grafts: Indications, Techniques and ResultsCardioVascular and Interventional Radiology, 2013
- 3-D printout of a DICOM file to aid surgical planning in a 6 year old patient with a large scapular osteochondroma complicating congenital diaphyseal aclasiaJournal of Radiology Case Reports, 2012
- Predictors of Abdominal Aortic Aneurysm Sac Enlargement After Endovascular RepairCirculation, 2011
- Clinical Applications of Physical 3D Models Derived From MDCT Data and Created by Rapid PrototypingAmerican Journal of Roentgenology, 2011
- Pragmatic Minimum Reporting Standards for Endovascular Abdominal Aortic Aneurysm RepairJournal of Endovascular Therapy, 2011
- Outcome and Safety of Aorfix™ Stent Graft in Highly Angulated Necks – A Prospective Observational Study (Arbiter 2)European Journal of Vascular and Endovascular Surgery, 2011
- Building virtual models by postprocessing radiology images: A guide for anatomy facultyAnatomical Sciences Education, 2010
- Endovascular versus Open Repair of Abdominal Aortic AneurysmNew England Journal of Medicine, 2010
- Abdominal aortic aneurysm and stent graft phantom manufactured by medical rapid prototypingJournal of Medical Engineering & Technology, 2002