Al-Cu layered composites fabricated by deformation
- 19 December 2018
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2053 (1) , 030028
Abstract
The paper presents first results of obtaining metal-matrix composites based on severe plastic deformation by shear under pressure of layered Al and Cu components. Three-layer composites with different alternation of layers, i.e. Al-Cu-Al and Cu-Al-Cu, were processed by constrained high pressure torsion to produce monolithic disk-shaped samples without pores. Analysis of the macroscopic homogeneity showed that different alternation of layers led to varying degrees of mixing of the starting components.Keywords
This publication has 11 references indexed in Scilit:
- Instabilities of interfaces between dissimilar metals induced by high pressure torsionMaterials Letters, 2018
- Mixing instabilities during shearing of metalsNature Communications, 2017
- Rapid synthesis of an extra hard metal matrix nanocomposite at ambient temperatureMaterials Science and Engineering: A, 2015
- On plastic deformation of bulk metallic glasses in Bridgman anvilsLetters on Materials, 2014
- Effect of grain boundaries on the electron work function of nanocrystalline nickelPhysics of the Solid State, 2013
- The dead metal zone in high-pressure torsionScripta Materialia, 2012
- Three-dimensional shear-strain patterns induced by high-pressure torsion and their impact on hardness evolutionActa Materialia, 2011
- Unusual macroscopic shearing patterns observed in metals processed by high-pressure torsionJournal of Materials Science, 2010
- A simulation study of the mixing, atomic flow and velocity profiles of crystalline materials during slidingWear, 2009
- Using high-pressure torsion for metal processing: Fundamentals and applicationsProgress in Materials Science, 2008