A High‐Fidelity Skin‐Attachable Acoustic Sensor for Realizing Auditory Electronic Skin
- 12 April 2022
- journal article
- research article
- Published by Wiley in Advanced Materials
- Vol. 34 (21) , e2109545
Abstract
Wearable auditory sensors are critical in user‐friendly sound‐recognition systems for smart human–machine interaction and the Internet of Things. However, previously reported wearable sensors have limited sound‐sensing quality as a consequence of a poor frequency response and a narrow acoustic‐pressure range. Here, a skin‐attachable acoustic sensor is presented that has higher sensing accuracy in wider auditory field than human ears, with flat frequency response (15–10 000 Hz) and a good range of linearity (29–134 dB SPL ) as well as high conformality to flexible surfaces and human skin. This high sound‐sensing quality is achieved by exploiting the low residual stress and high processability of polymer materials in a diaphragm structure designed using acousto‐mechano‐electric modeling. Thus, this acoustic sensor shows high acoustic fidelity by sensing human‐audible sounds, even loud sounds and low‐frequency sounds that human ears cannot detect without distorting them. The polymer‐based ultrasmall (2 ) and thin sensor maintains sound‐detection quality on flexible substrates and in a wide temperature range (25 to 90 °C). The acoustic sensor shows a significant potential of auditory electronic skin, by recognizing voice successfully when the sensor attached on human skin is connected to a commercial mobile device running the latest artificial intelligence assistant.Keywords
Funding Information
- National Research Foundation of Korea
This publication has 40 references indexed in Scilit:
- Eardrum‐Inspired Active Sensors for Self‐Powered Cardiovascular System Characterization and Throat‐Attached Anti‐Interference Voice RecognitionAdvanced Materials, 2015
- Environmental sound recognition: a surveyAPSIPA Transactions on Signal and Information Processing, 2014
- Implementation of the CMOS MEMS Condenser Microphone with Corrugated Metal Diaphragm and Silicon Back-PlateSensors, 2011
- Fabrication of thin SU-8 cantilevers: initial bending, release and time stabilityJournal of Micromechanics and Microengineering, 2010
- Soft lithography for micro- and nanoscale patterningNature Protocols, 2010
- Processing of thin SU-8 filmsJournal of Micromechanics and Microengineering, 2008
- Robot‐by‐voice: experiments on commanding an industrial robot using the human voiceIndustrial Robot: the international journal of robotics research and application, 2005
- A new measurement microphone based on MEMS technologyJournal of Microelectromechanical Systems, 2003
- High-performance condenser microphone with fully integrated CMOS amplifier and DC-DC voltage converterJournal of Microelectromechanical Systems, 1998
- A subminiature condenser microphone with silicon nitride membrane and silicon back plateThe Journal of the Acoustical Society of America, 1989