Mechanical and thermal behavior of cellulose nanocrystals-incorporated Acrodur® sustainable hybrid composites for automotive applications
Authors:
- 22 March 2020
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 54 (22) , 3159-3169
Abstract
Utilization of cellulose nanocrystals as an additive in the formulation of biocomposites made with Acrodur® resin is presented. Natural fibers/polyethylene terephthalate mats were impregnated with Acrodur® and hot-pressed into the final thickness of 3 mm after drying. Biocomposites with 2 wt.% and 5 wt.% cellulose nanocrystal (dry-basis) were also produced. The produced biocomposite panels were then tested to determine the flexural strength, flexural modulus and Izod impact strength. The results revealed that adding cellulose nanocrystal to the composite formulation increased flexural modulus significantly up to 970 MPa (17.5% increase) at a panel density of 0.5 g/cm3, while it did not significantly affect flexural strength values. A slight reduction was observed in the impact strength of the samples by adding cellulose nanocrystal. The fractured samples of impact test were observed under a scanning electron microscope. It was shown that in all cases, the fracture happened due to the failure of the fibrous system and in particular natural fibers. Thermal stability of the composites was also investigated using thermo-gravimetric analysis. It was found that adding cellulose nanocrystal slightly reduced the thermal stability of the biocomposites. Potential compatibility of cellulose nanocrystal particles with Acrodur® resin is promising and the improvement in flexural modulus can lead to the design of lighter parts for automotive applications such as door panels, headliners, and underbody shields.Keywords
This publication has 29 references indexed in Scilit:
- Cellulose Nanomaterials—Binding Properties and Applications: A ReviewMolecules, 2018
- Effect of fibre surface treatment on interfacial and mechanical properties of non‐woven kenaf fibre reinforced acrylic based polyester compositesPolymer Composites, 2017
- Utilization of Cellulose Nanofibrils as a Binder for Particleboard ManufactureBioResources, 2017
- Cellulose Nanomaterials as Binders: Laminate and Particulate SystemsJournal of Renewable Materials, 2016
- Review of the applications of biocomposites in the automotive industryPolymer Composites, 2016
- Optimization of Processing Conditions Via Response Surface Methodology (RSM) of Nonwoven Flax Fibre Reinforced Acrodur BiocompositesProcedia Chemistry, 2016
- Innovative flax tapes reinforced Acrodur biocomposites: A new alternative for automotive applicationsMaterials & Design (1980-2015), 2014
- Optimising processing conditions of flax fabric reinforced Acrodur biocompositesJournal of Composite Materials, 2013
- Nanocellulose2012
- Kenaf fiber/soy protein based biocomposites modified with poly(carboxylic acid) resinJournal of Applied Polymer Science, 2012