Bond Behavior between NSM CFRP Strips and Concrete Exposed to Elevated Temperature Using Cement-Based and Epoxy Adhesives
Authors:
- 1 October 2017
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Composites for Construction
- Vol. 21 (5)
Abstract
The repair and strengthening of existing concrete structures with composite material has become more common during the last decade. The near-surface-mounted (NSM) technique was used in this research, where fiber-reinforced polymer (FRP) laminates were bonded using an epoxy or cement-based adhesive in grooves cut into the concrete surface to study the behavior of the bond between the NSM carbon fiber–reinforced polymer (CFRP) strips and concrete after exposure to heating. Twenty-four heat-damaged concrete prisms were tested using a single-lap shear test. The results were compared with 24 reference specimens without heat damage. The results demonstrate that the residual bond strength after the repair of heat-damaged concrete with CFRP using epoxy adhesive is 94, 79, and 49% for temperature exposure of 1 h at 200, 400, and 600°C, respectively. The corresponding values for 2 h of exposure are 86, 75, and 41%, respectively. However, the residual bond strength after the repair of heat-damaged concrete with CFRP using cement-based adhesive is 91, 79, and 70% for temperature exposure of 1 h at 200, 400, and 600°C, respectively. The corresponding values for 2 h of exposure are 85, 69, and 66%, respectively.Keywords
This publication has 12 references indexed in Scilit:
- Fire‐damaged R/C Members Repair With High‐Performance Fibre‐Reinforced JacketStrain, 2011
- Repair of heat-damaged reinforced concrete slabs using fibrous composite materialsConstruction and Building Materials, 2011
- Evaluating residual properties of thermally damaged concreteCement and Concrete Composites, 2008
- Effects of elevated temperatures on properties of concreteFire Safety Journal, 2007
- Bond Behavior of Near-Surface Mounted CFRP Laminate Strips under Monotonic and Cyclic LoadingJournal of Composites for Construction, 2006
- Bond–slip models for FRP sheets/plates bonded to concreteEngineering Structures, 2005
- Mechanical properties of high-strength concrete after fireCement and Concrete Research, 2004
- A modified pull-out test for bond of near-surface mounted FRP rods in concreteComposites Part B: Engineering, 2002
- Brittle Failure and Bond Development Length of CFRP-Concrete BeamsJournal of Composites for Construction, 2001
- Compressive strength and pore structure of high-performance concrete after exposure to high temperature up to 800°CCement and Concrete Research, 2000