Enhanced electrochemical performance of bulk type oxide ceramic lithium batteries enabled by interface modification
- 22 November 2017
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 6 (11) , 4649-4657
Abstract
The interface issue is one of the severe problems in all-solid-state (ASS) batteries, especially for oxide-type batteries with a full ceramic structure. Rigid interfacial contact between electrodes and electrolyte and poor mechanical properties of ceramics limit the choices of applicable materials and fabrication processes for ASS batteries. In this report, a bulk type ASS lithium battery with an initial discharge capacity of 112.7 mA h g−1 is successfully fabricated. A garnet-structured Li6.75La3Zr1.75Ta0.25O12 (LLZO-Ta) ceramic pellet is used as the solid electrolyte. A slurry of a composite cathode consisting of Li[Ni0.5Co0.2Mn0.3]O2, In2(1−x)Sn2xO3, Li3BO3, and polyvinylidene fluoride was tape-cast on the LLZO-Ta pellet and annealed to improve the interfacial contact among the particles in the composite cathode as well as between the composite cathode and the electrolyte pellet. Without the surface modification of a Li[Ni0.5Co0.2Mn0.3]O2 active material, an obvious degradation of discharge capacity due to polarization is observed during cycling. When a layer of a Li–Ti–O precursor is coated on the surface of Li[Ni0.5Co0.2Mn0.3]O2 particles, in situ spinel Li[Ti0.1Mn0.9]2O4 is formed at the surface after annealing, leading to an enhancement of discharge capacity of the battery and great improvement for cycling stability. This novel method of interface modification reduces the interfacial polarization with an enhanced Li+ transfer between the cathode and the electrolyte. Our experimental results reveal that the interface engineering by means of reasonable regulation on the surface constituent of electrode materials can effectively improve the capacity and cycling stability of ASS lithium batteries.Keywords
Funding Information
- National Natural Science Foundation of China (51532002)
- National Natural Science Foundation of China (51572149)
This publication has 38 references indexed in Scilit:
- High rate capabilities of all-solid-state lithium secondary batteries using Li4Ti5O12-coated LiNi0.8Co0.15Al0.05O2 and a sulfide-based solid electrolyteJournal of Power Sources, 2011
- Inorganic solid Li ion conductors: An overviewSolid State Ionics, 2009
- The fast lithium-ion conducting oxides Li3xLa2/3−xTiO3 from fundamentals to applicationSolid State Ionics, 2008
- Building better batteriesNature, 2008
- LiNbO3-coated LiCoO2 as cathode material for all solid-state lithium secondary batteriesElectrochemistry Communications, 2007
- Developments of high-voltage all-solid-state thin-film lithium ion batteriesJournal of Power Sources, 2006
- An all-solid-state thin film battery using LISIPON electrolyte and Si–V negative electrode filmsElectrochemistry Communications, 2003
- A Nanocrystalline NiO Thin-Film Electrode Prepared by Pulsed Laser Ablation for Li-Ion BatteriesJournal of the Electrochemical Society, 2002
- Understanding the Anomalous Capacity of Li/Li[Ni[sub x]Li[sub (1/3−2x/3)]Mn[sub (2/3−x/3)]]O[sub 2] Cells Using In Situ X-Ray Diffraction and Electrochemical StudiesJournal of the Electrochemical Society, 2002
- Fabrication and characterization of amorphous lithium electrolyte thin films and rechargeable thin-film batteriesJournal of Power Sources, 1993