Fracture Toughness of a Silane Coupled Polymer-Metal Interface: Silane Concentration Effects
- 1 March 2005
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 81 (3-4) , 347-370
Abstract
Fracture toughness of joints made from a glassy, 343,000 molecular weight polystyrene block bonded to chromic-sulfuric acid etched or phosphoric acid anodized aluminum are investigated. The fracture tests are performed with a 90-degree peel apparatus under “dry” laboratory conditions and “wet” conditions created by submerging the apparatus in a temperature controlled water bath. The bond strengths are controlled using various concentrations of styrl silane coupling agent added directly into the styrene monomer solution that polymerizes against the aluminum. Ellipsometric measurements on smooth silicon surfaces verify that the thickness of bound polymer is controlled by the silane to polystyrene mole ratio. X-ray photoelectron spectroscopy (XPS) analysis of fractured surfaces indicates that the fracture is near the aluminum surface. Both the wet and dry fracture energy as a function of bound polymer thickness on acid etched aluminum joints resemble quite closely the adhesion literature results obtained by fracturing pairs of fused, immiscible glassy polymers. Reasons for this similarity are discussed.Keywords
This publication has 21 references indexed in Scilit:
- CRACK GROWTH OF STRUCTURAL ADHESIVE JOINTS IN HUMID ENVIRONMENTSThe Journal of Adhesion, 2004
- Interface/Interphase engineering of polymers for adhesion enhancement: Part I. Review of micromechanical aspects of polymer interface reinforcement through surface grafted molecular brushesThe Journal of Adhesion, 2003
- Influence of surface morphology on the adhesion strength of epoxy–aluminum interfacesJournal of Adhesion Science and Technology, 2003
- The Influence of Adherend Topography on the Fracture Toughness of Aluminium-Epoxy Adhesive Joints in Humid EnvironmentsThe Journal of Adhesion, 2001
- Mechanical Properties of Homopolymer Interfaces: Transition from Simple Pullout To Crazing with Increasing Interfacial WidthMacromolecules, 1999
- Direct Correlation between Interfacial Width and Adhesion in Glassy PolymersMacromolecules, 1998
- The Fatigue and Durability Behaviour of Automotive Adhesives. Part I: Fracture Mechanics TestsThe Journal of Adhesion, 1997
- Diffusion of water into an epoxy adhesive: comparison between bulk behaviour and adhesive jointsInternational Journal of Adhesion and Adhesives, 1995
- A molecular interpretation of the toughness of glassy polymersMacromolecules, 1991
- Adhesion and durability of metal-polymer bondsJournal of Materials Science, 1984