Design and performance analysis of stand-alone PV system at Al-Nahrain University, Baghdad, Iraq
Open Access
- 1 June 2020
- journal article
- research article
- Published by Institute of Advanced Engineering and Science in International Journal of Power Electronics and Drive Systems (IJPEDS)
- Vol. 11 (2) , 921-930
Abstract
The use of the stand-alone PV systems for electric power generation is important to meet the needs of electric power, especially in countries that have major problems in the generation and continuity of electricity such as Iraq. The aim of this research is to design and simulate a stand-alone PV system installed on the roof of the parking garage in the College of Engineering at Al-Nahrain University for the purpose of using the electrical energy generated by this system to meet the energy demand of the daily light for the parking garage and engineering laboratories buildings beside it. The main factor in the design was the total area of the roof of the parking garage. The Pvsyst6 program is used to simulate the suggested PV system and to determine the effect of partial shading which caused by the trees surrounding the garage on the available generated power of the system. A comparison was made between four types of solar panels to see the suitability of these types to the weather conditions in Iraq, in addition to the impact of the shadows surrounding the garage. These types of solar panels were (CIS SL2-145, CdTe F-4112-3, Poly JAP6-60-260, and Mono JAM6-60-260), CdTe type showed better performance compared to other types in terms of available energy generated because it has small losses due to temperature and shadows. It was found that the best tilt angle of the solar panels in the case of shadows is 19o to the south. Finally, the financial analysis was made to see the economic feasibility of this PV system and it is found that the PV system that uses CdTe panels has the smallest kWh unit price (0.236 $/kWh) as compared with the other three types.Keywords
This publication has 7 references indexed in Scilit:
- Reconfiguration strategies for reducing partial shading effects in photovoltaic arrays: State of the artSolar Energy, 2019
- Design and Optimization of Solar Carport Canopies for Maximum Power Generation and Efficiency at BahawalpurInternational Journal of Photoenergy, 2019
- Techno-economic evaluation of installing EV and PV combined infrastructure on Academic Institution’s Parking Garages in Illinois, USAAIMS Energy, 2019
- Design and Simulation of Stand-alone PV System for Electronic and Communications Engineering Department Laboratories in Al-Nahrain UniversityEAI Endorsed Transactions on Energy Web, 2018
- Assessment of PV Power Generation for Household in Surabaya Using SolarGIS–pvPlanner SimulationEnergy Procedia, 2014
- Optimal Photovoltaic Array Reconfiguration to Reduce Partial Shading LossesIEEE Transactions on Sustainable Energy, 2012
- Optimization and life-cycle cost of health clinic PV system for a rural area in southern Iraq using HOMER softwareSolar Energy, 2010