The Analytical Prediction of Thermal Distribution and Defect Generation of Inconel 718 by Selective Laser Melting
Open Access
- 19 October 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (20) , 7300
Abstract
In selective laser melting, the rapid change of the temperature field caused by the rapid movement of the laser causes the instability of the melt pool flow, resulting in a generation of defects, such as lack of fusion, keyholing and balling effect, which greatly affect the performance of parts. In order to fully understand the temperature distribution and defect generation process of selective laser melting (SLM), experimental research, numerical simulation and analytical methods are mainly applied. The analytical method is suitable for the determination of the optimal process parameters because it is simple and consumes fewer resources. In a simulation, the absorptivity of the material is usually regarded as a constant, but experimental studies have shown that absorptivity is related to temperature, laser power, scanning speed, layer thickness and other process parameters. Considering the dynamics of thermal physical properties of Inconel 718, an improved analytical method was proposed and successfully applied to thermal analysis and the prediction of melt pool size. By comparing with the results of finite element simulation, experiment and other analytical solutions, the ease of use and effectiveness of the method are verified. Based on the prediction of the melt pool and the criterion of internal defects, the combination of process parameters that produce internal defects is calculated, which will make it possible to quickly obtain ideal process parameters.Keywords
Funding Information
- Science and Technology Foundation of State Key Laboratory (9100419010)
- Fundamental Research Funds for the Central Universities (2017MS150)
This publication has 26 references indexed in Scilit:
- Prediction of lack-of-fusion porosity for powder bed fusionAdditive Manufacturing, 2017
- Numerical and experimental investigations of micro and macro characteristics of direct metal laser sintered Ti-6Al-4V productsJournal of Materials Processing Technology, 2017
- Correlation between porosity and processing parameters in TiAl6V4 produced by selective laser meltingMaterials & Design, 2016
- Optimizing quality of additively manufactured Inconel 718 using powder bed laser melting processAdditive Manufacturing, 2016
- The status, challenges, and future of additive manufacturing in engineeringComputer-Aided Design, 2015
- Experimental investigation and statistical optimisation of the selective laser melting process of a maraging steelOptics & Laser Technology, 2015
- Observation of keyhole-mode laser melting in laser powder-bed fusion additive manufacturingJournal of Materials Processing Technology, 2014
- Finite element simulation of the temperature and stress fields in single layers built without-support in selective laser meltingMaterials & Design (1980-2015), 2013
- Mesoscopic simulation of selective beam melting processesJournal of Materials Processing Technology, 2011
- Single track formation in selective laser melting of metal powdersJournal of Materials Processing Technology, 2010