Microwave cavity perturbation technique for high-temperature dielectric measurements
- 1 June 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 0149645X,p. 1-4
Abstract
The present work is motivated by the use of microwaves for the catalytic conversion of carbon dioxide to carbon monoxide. Chemical reactions like this are running at catalyst temperatures of more than 800 °C. The appropriate design of the microwave assisted reactor requires the exact knowledge of the dielectric properties of the catalyst and catalyst support materials up to those high temperatures. For this purpose a measurements system based on the cavity perturbation method was built. The system is using a rectangular TE 104 cavity with a resonance frequency at 2.45 GHz and a quality factor Q ≈ 12000. A novel synthetic calibration method based on numerical full-wave modeling has been developed as an alternative to traditional calibration methods. The results of high temperature dielectric measurements for polyether ether ketone (PEEK), MACOR glass ceramics and zirconia are presented.Keywords
This publication has 6 references indexed in Scilit:
- A microwave applicator for high homogeneous high temperature heating of catalysts2013
- Development of a microwave calorimeter for simultaneous thermal analysis, infrared spectroscopy and dielectric measurementsMeasurement Science and Technology, 2004
- Microwave Electronics2004
- Correction Procedures for The measurement of Permittivities with the Cavity Perturbation MethodJournal of Microwave Power and Electromagnetic Energy, 1995
- An intercomparison of techniques for measuring dielectric permittivity and loss over a wide frequency rangeJournal of Nuclear Materials, 1992
- Dynamic measurement of temperature dependence of complex permittivities at microwave frequencyElectronics and Communications in Japan (Part I: Communications), 1986