Formation of nitrided layers on duplex steel – influence of multiphase substrate
Authors:
- 1 May 2010
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 26 (4) , 299-304
Abstract
The present paper reports the results of gas nitriding of duplex stainless steel and study of the effect of substrate structure on the nitrided layers. The differences in the growth of the layers on austenitic and ferritic substrate were studied. The microstructure and phase composition of the layers were investigated using light microscopy analysis), X-ray diffraction (XRD and grazing angle XRD – GXRD) and electron microprobe spectrometry. Moreover, the microhardness of the layers was studied. A particular role of steel substrate in layer formation was observed at a low temperature (below 500°C) nitriding. The layers were mostly composed of the S phase and expanded martensite formed on austenite and ferrite grains respectively. The substrate influence was of minor importance at treatment temperature higher than 500°C.Keywords
This publication has 14 references indexed in Scilit:
- On the microstructure and phase identification of plasma nitrided 17-4PH precipitation hardening stainless steelSurface and Coatings Technology, 2008
- Improvement of corrosion and wear resistances of AISI 420 martensitic stainless steel using plasma nitriding at low temperatureSurface and Coatings Technology, 2008
- Effect of DC plasma nitriding temperature on microstructure and dry-sliding wear properties of 316L stainless steelSurface and Coatings Technology, 2008
- Corrosion behavior of ion nitrided AISI 316L stainless steelThin Solid Films, 2008
- Corrosion properties of plasma nitrided AISI 410 martensitic stainless steel in 3.5% NaCl and 1% HCl aqueous solutionsCorrosion Science, 2006
- Corrosion resistance of nitrided layers on austenitic steelSurface and Coatings Technology, 2006
- Microstructure and properties of layers on chromium steelSurface and Coatings Technology, 2006
- Plasma nitriding of stainless steels at low temperaturesSurface and Coatings Technology, 1999
- Duplex stainless steels1997
- Plasma immersion ion implantation of stainless steel: austenitic stainless steel in comparison to austenitic-ferritic stainless steelSurface and Coatings Technology, 1996