Effect of Al2O3 particles on the mechanical and wear properties of Al base composites
- 22 December 2022
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 237 (13) , 3063-3072
Abstract
In this study as its novelty, Al/Al2O3 composites have been fabricated combined stir casting and accumulative roll bonding (ARB) process. Then, the next step was the investigation of the effect of Nano Al2O3 Vol.% on mechanical, wear and microstructural properties of these kind of composites. After the 4th cycle, an excellent particle distribution through the aluminum matrix has been achieved. Then, mechanical properties, wear resistance and microstructural properties have been investigated. The results showed that by higher the alumina Vol.% contents, the strength of these composites were enhanced and the elongation of samples decreased. Also, by increasing alumina content into the Al matrix through stir casting process, a significant increase in wear resistance was achieved.Keywords
This publication has 26 references indexed in Scilit:
- Effect of W particles on the properties of accumulatively roll-bonded Al/W compositesMaterials Science and Engineering: A, 2012
- Using ARB process as a solution for dilemma of Si and SiCp distribution in cast Al–Si/SiCp compositesJournal of Materials Processing Technology, 2011
- Comparison of nanostructured Al/B4C composite produced by ARB and Al/B4C composite produced by RRB processMaterials Science and Engineering: A, 2010
- Manufacturing of high-strength aluminum/alumina composite by accumulative roll bondingMaterials Science and Engineering: A, 2010
- Nano-grained 70/30 brass strip produced by accumulative roll-bonding (ARB) processMaterials Science and Engineering: A, 2010
- Significant enhancement of bond strength in the accumulative roll bonding process using nano-sized SiO2 particlesJournal of Materials Processing Technology, 2009
- Investigation of roll bonding between aluminum alloy stripsMaterials & Design (1980-2015), 2008
- Fabrication and characterisation of Al–7Si–0.35Mg/fly ash metal matrix composites processed by different stir casting routesComposites Science and Technology, 2007
- Adhesive wear behaviour of B4C and SiC reinforced 4147 Al matrix composites (Al/B4C–Al/SiC)Journal of Materials Processing Technology, 2005
- Novel ultra-high straining process for bulk materials—development of the accumulative roll-bonding (ARB) processActa Materialia, 1999