Internal stresses in TiN/Ti multilayer coatings deposited by large area filtered arc deposition
- 1 November 2008
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 104 (9) , 093502
Abstract
A series of TiN/Ti multilayer coatings with fixed TiN layer thickness and different Ti layer thicknesses were deposited using a large area filtered arc deposition technique. X-ray diffraction was used to investigate the crystalline structure, lattice strain, and crystallinity of the deposited coatings. A substrate curvature method was used to measure the internal stress in the multilayer coatings. The influence of the Ti interlayer thickness on the crystalline structure and internal stress in the coatings was systematically studied. It was found that a cubic TiN phase and hexagonal Ti phase exist in all the multilayer coatings. The TiN and Ti layers in the multilayer coatings exhibit a strong (111) and (002) preferred orientation, respectively. With the increase in the Ti layer thickness, the -spacing decreases and the peak width increases for both TiN (111) and Ti (002) peaks, indicating a decrease in the lattice strain and an increase in the crystallinity of both TiN and Ti phases. It is suggested, that the reduction in the defect density in both TiN and Ti layers and the relaxation of the stain by the diffusion of the Ti atoms in the underneath Ti layer contribute to the decrease in the total internal stress with increasing Ti layer thickness.
Keywords
This publication has 28 references indexed in Scilit:
- Crystallization, stress, and stress-relieve due to nickel in amorphous silicon thin filmsJournal of Applied Physics, 2007
- High thickness Ti/TiN multilayer thin coatings for wear resistant applicationsSurface and Coatings Technology, 2006
- Relaxation of process induced surface stress in amorphous silicon carbide thin films using low energy ion bombardmentApplied Physics Letters, 2006
- X-ray residual stress analysis on CrN/Cr/CrN multilayer PVD coatings deposited on different steel substratesSurface and Coatings Technology, 2006
- Coating internal stress measurement through the curvature method: A geometry-based criterion delimiting the relevance of Stoney's formulaSurface and Coatings Technology, 2006
- Aspects of plasma-enhanced magnetron-sputtered deposition of hard coatings on cutting toolsSurface and Coatings Technology, 2002
- Characterization of large area filtered arc deposition technology: part II — coating properties and applicationsSurface and Coatings Technology, 2001
- Characterization of large area filtered arc deposition technology: part I — plasma processing parametersSurface and Coatings Technology, 2001
- Improvement of mechanical properties of Ti/TiN multilayer film deposited by sputteringSurface and Coatings Technology, 2001
- A simple model for the formation of compressive stress in thin films by ion bombardmentThin Solid Films, 1993