Biobutanol separation from ABE model solutions and fermentation broths using a combined adsorption–gas stripping process
Authors:
- 11 March 2016
- journal article
- research article
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 92 (1) , 245-251
Abstract
BACKGROUND: Butanol is considered a promising sustainable biofuel to partly replace petroleum‐based fuels. However, to become an economically viable biofuel, some challenges need to be overcome in the biobutanol production process such as the low final product concentration caused by product toxicity to the microorganism. Few separation techniques have been proposed to extract biobutanol in situ or ex situ from dilute fermentation broths. In this investigation, the combination of gas stripping and adsorption has been studied experimentally as a process to effectively separate butanol from dilute model solutions and fermentation broths using the advantages of both separation techniques.RESULTS: Results showed that the butanol adsorption capacity of activated carbon F‐400 was 261 mg g−1, for a stripped gas stream from butanol–water binary solution with an initial liquid phase composition of 15 g L−1 butanol, which ended up having a vapour phase composition of 5.8 mg L−1 after gas stripping. This capacity is relatively high compared with the values reported in the literature. Butanol adsorption capacities for a stripped gas stream in equilibrium with ABE model solutions (5.1 mg L−1) and fermentation broths (2.3 mg L−1) for this adsorbent (211.6 and 219.8 mg g−1, respectively), were also higher than the capacities reported in the literature.CONCLUSION: Combined gas stripping and adsorption could be considered an effective technique for biobutanol separation processes. © 2016 Society of Chemical IndustryKeywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 34 references indexed in Scilit:
- Butanol vapor adsorption behavior on active carbons and zeolite crystalApplied Surface Science, 2015
- Adsorption of Water and Butanol in Silicalite-1 Film Studied with in Situ Attenuated Total Reflectance–Fourier Transform Infrared SpectroscopyLangmuir, 2015
- Acetone–butanol–ethanol competitive sorption simulation from single, binary, and ternary systems in a fixed‐bed of KA‐I resinBiotechnology Progress, 2014
- Pervaporative separation of butanol using a composite PDMS/PEI hollow fiber membraneJournal of Industrial and Engineering Chemistry, 2014
- Separation techniques in butanol production: Challenges and developmentsBiomass and Bioenergy, 2014
- Experimental studies on the effect of injection timing in a SI engine using dual injection of n-butanol and gasoline in the intake portFuel, 2014
- Recovery of Dilute Aqueous Acetone, Butanol, and Ethanol with Immobilized Calixarene CavitiesACS Applied Materials & Interfaces, 2013
- In-cylinder spectroscopic measurements of knocking combustion in a SI engine fuelled with butanol–gasoline blendEnergy, 2013
- Adsorbent screening for biobutanol separation by adsorption: kinetics, isotherms and competitive effect of other compoundsAdsorption, 2013
- Adsorption of n-Butanol from Dilute Aqueous Solution with Grafted CalixarenesLangmuir, 2011