Investigation of Temperature Distribution and Heat Transfer in Fluidized Bed Using a Combined CFD-DEM Model
- 29 April 2011
- journal article
- research article
- Published by Taylor & Francis in Drying Technology
- Vol. 29 (6) , 697-708
Abstract
Fluidized beds are widely used in many industries because they are effective for both mixing and drying. The distinct element method (DEM) has recently received more attention for investigating the phenomena of multiphase flow because the technique is effective in gathering detailed information on complex phenomena without physically disturbing the flows. However, most studies have focused on the aerodynamics of the particles. In this study, a combined computational fluid dynamics (CFD)-DEM model, which allows prediction of gas and particle temperature profiles and heat transfer coefficients in a two-dimensional fluidized bed, was developed. The predicted results were compared with the experimental results at the superficial gas velocities of 2.04, 2.22, and 2.41 m/s and at the controlled inlet temperature of 343 K. Based on the comparison between the predicted and experimental results, it was found that the developed model performed adequately in predicting the gas temperature profiles, and the predicted particle temperature profiles were higher than the experimental data. The predicted heat transfer coefficient was slightly higher than the experimental data. However, the predicted and experimental results had a similar trend in which the heat transfer coefficient increased as a function of an increase in superficial gas velocity. In addition, the minimum fluidization velocity predicted by the developed model agreed well with the experimental data. Such predictions can provide essential information on temperature and heat transfer coefficients inside the fluidized bed for design and scale-up.Keywords
This publication has 37 references indexed in Scilit:
- Heat and mass transfer during drying of a bed of shrinking particles – Simulation for carrot cubes dried in a spout-fluidized-bed drierInternational Journal of Heat and Mass Transfer, 2008
- CFD modeling of the gas–particle flow behavior in spouted bedsPowder Technology, 2008
- Evaluation of heat transfer coefficient in gas–solid fluidized beds using cluster-based approachPowder Technology, 2007
- Numerical simulation of two-dimensional fluidized beds using the discrete element method (comparison between the two- and three-dimensional models)Powder Technology, 1998
- HOW TO USE FLUIDIZATION TO OBTAIN DRYING KINETICS COUPLED WITH QUALITY EVOLUTIONDrying Technology, 1997
- DRYING CHARACTERISTICS OF CORN IN FLUIDIZED BED DRYERDrying Technology, 1997
- OPTIMUM STRATEGY FOR FLUIDIZED BED PADDY DRYINGDrying Technology, 1994
- Discrete particle simulation of two-dimensional fluidized bedPowder Technology, 1993
- Lagrangian numerical simulation of plug flow of cohesionless particles in a horizontal pipePowder Technology, 1992
- A theoretical analysis of heat transfer due to particle impactInternational Journal of Heat and Mass Transfer, 1988