Thermal performance enhancement of melting and solidification process of phase‐change material in triplex tube heat exchanger using longitudinal fins
Authors:
- 3 December 2018
- journal article
- research article
- Published by Wiley in Heat Transfer
- Vol. 48 (2) , 483-501
Abstract
Efficient application of intermittent renewable energy sources, like solar, waste heat recovery, and so forth, depends on a large extent on the thermal energy storage methods. Latent heat energy storage with the use of phase‐change material (PCM) is the most promising one because it stores large energy in the form of latent heat at a constant temperature. The current study investigates melting and solidification of PCM in the triplex tube heat exchanger (TTHX) numerically. The two‐dimensional numerical model has been developed using Ansys Fluent 16.2, which considers the effects of conduction as well as natural convection. To overcome the limitation imposed by the poor thermal conductivity of PCM, use of fins is the better solution. In the current study, longitudinal fins are used for better performance of TTHX, which increases heat‐transfer area between PCM and heat‐transfer fluid. The effects of location of fins, that is, internal, external, and combined internal‐external fins, are observed. All three configurations improve melting as well as solidification process. During the melting process, internal and combined internal‐external fins are equally efficient, in which maximum 59% to 60% reduction in melting time is achieved. For solidification, internal‐external fins combination gives maximum 58% reduction in solidification time.Keywords
This publication has 19 references indexed in Scilit:
- Experimental study of the phase change heat transfer inside a horizontal cylindrical latent heat energy storage systemInternational Journal of Thermal Sciences, 2014
- Modeling phase change materials behavior in building applications: Comments on material characterization and model validationRenewable Energy, 2014
- Thermal Performance of a Phase Change Material‐Based Latent Heat Thermal Storage UnitHeat Transfer, 2013
- Experimental study of PCM melting in triplex tube thermal energy storage for liquid desiccant air conditioning systemEnergy and Buildings, 2013
- A combined experimental and computational study on the melting behavior of a medium temperature phase change storage material inside shell and tube heat exchangerInternational Communications in Heat and Mass Transfer, 2012
- Experimental investigation on heat recovery from diesel engine exhaust using finned shell and tube heat exchanger and thermal storage systemApplied Energy, 2011
- A comparison of heat transfer enhancement in a medium temperature thermal energy storage heat exchanger using finsSolar Energy, 2009
- Utilization of phase change materials in solar domestic hot water systemsRenewable Energy, 2009
- Natural convection heat transfer coefficients in phase change material (PCM) modules with external vertical finsApplied Thermal Engineering, 2008
- An analysis of isothermal phase change of phase change material within rectangular and cylindrical containersSolar Energy, 2001