Surface Modification of Ceramic‐Supported Polyethersulfone Membranes by Interfacial Polymerization for Reduced Membrane Fouling
Authors:
- 22 September 2005
- journal article
- research article
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 206 (19) , 1934-1940
Abstract
Summary: This study reports a simple and effective route for the hydrophilic surface modification of ceramic‐supported polyethersulfone membranes by synthesizing a poly(vinyl alcohol)/polyamide composite thin surface layer with an interfacial polymerization method. The fabricated membranes were characterized with XPS, SEM, and contact angle measurements, and the effects of hydrophilic surface modification on the membrane flux and oil rejection in the treatment of oil‐in‐water (O/W) microemulsions were experimentally studied. All the characterizations and filtration results showed that, the hydrophilic surface modification was achieved successfully and consequently reduced the membrane fouling effectively. The presented route is valuable for developing robust membranes with a low level of membrane fouling in the separation of O/W microemulsions. Hydrophilic surface modification resulted in enhanced membrane performance. magnified image Hydrophilic surface modification resulted in enhanced membrane performance.Keywords
This publication has 10 references indexed in Scilit:
- Antifouling Polymer Membranes with Subnanometer Size SelectivityMacromolecules, 2004
- Effect of hydrophilicity on fouling of an emulsified oil wastewater with PVDF/PMMA membranesJournal of Membrane Science, 2003
- Surface modification of ultrafiltration membranes by preadsorption of a negatively charged polymerJournal of Membrane Science, 2003
- Membrane Surface Modification by Plasma-Induced Polymerization of Acrylamide for Improved Surface Properties and Reduced Protein FoulingLangmuir, 2002
- Hydrophilic modification of polyethersulfone membranes by low temperature plasma-induced graft polymerizationJournal of Membrane Science, 2002
- Fouling and rejection behavior of ceramic and polymer-modified ceramic membranes for ultrafiltration of oil-in-water emulsions and microemulsionsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2001
- Surface modification of polypropylene membranes by γ-ray induced graft copolymerization and their solute permeation characteristicsJournal of Membrane Science, 2001
- Fouling-resistant ceramic-supported polymer membranes for ultrafiltration of oil-in-water microemulsionsJournal of Membrane Science, 2001
- Membrane fouling reduction by backpulsing and surface modificationJournal of Membrane Science, 2000
- Development of membranes with low surface energy to reduce the fouling in ultrafiltration applicationsJournal of Membrane Science, 1997