On the Fatigue Strength of Welded High-Strength Steel Joints in the As-Welded, Post-Weld-Treated and Repaired Conditions in a Typical Ship Structural Detail
Open Access
- 19 March 2023
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 11 (3) , 644
Abstract
Weld quality and life extension methods of welded details in ship structures made of high-strength and ultra-high-strength steels are of high importance to overcome the issues related to the fatigue characteristics of welded high-strength steels. The current work experimentally and numerically investigated the fatigue strength of a longitudinal stiffener detail, typically present in the bulkhead connections of ship hull. Two high-strength steel grades, namely EQ47TM and EQ70QT steels, were studied in welded plate connections using gas metal arc welding with rutile-cored wires. Fatigue tests were carried out on both small-scale specimens under axial and large-scale beam specimens under four-point bending loading. In addition to the joints tested in the as-welded condition, the high-frequency mechanical impact (HFMI) treatment was considered as a post-weld treatment technique in the fatigue test series. Furthermore, the large-scale beam specimens were pre-fatigued until substantial fatigue cracks were observed, after which they were re-tested after weld repairing and post-weld treatments to investigate the potential to rehabilitate fatigue-cracked ship details. The joints in the as-welded condition were performed in accordance with the current design recommendations. Due to the severe transition from the base material to the weld reinforcement in the joints welded with the rutile-cored wire, a successful HFMI treatment required geometrical modification of weld toe using a rotary burr to avoid any detrimental sub-cracks at the HFMI-treated region. Alternatively, the use of solid filler wires could potentially overcome these issues related to the welding quality. Repaired and post-weld-treated welds performed well in the re-tests, and the fatigue strength was almost twice higher than that of tests in the as-welded condition.Keywords
Funding Information
- Business Finland (7386/31/2018, 5498/31/2021)
- Business Finland (7386/31/2018, 5498/31/2021)
This publication has 26 references indexed in Scilit:
- Recommendations for Fatigue Design of Welded Joints and Components2016
- Assessment of fatigue strength of steel butt-welded joints in as-welded condition – Alternative approaches for curve fitting and mean stress effect analysisMarine Structures, 2015
- Influence of weld geometry and residual stresses on the fatigue strength of longitudinal stiffenersWelding in the World, 2013
- Effect of high-strength filler metals on the fatigue behaviour of butt jointsWelding in the World, 2012
- On Relation Between Fatigue Properties Of Welded Joints, Quality Criteria and Groups in Iso 5817Welding in the World, 2012
- Fatigue Strength Of Thin- Plated Block Joints With Typical Shipbuilding ImperfectionsWelding in the World, 2012
- Fatigue strength of welded butt joints in thin and slender specimensInternational Journal of Fatigue, 2012
- Development of Weld Quality Criteria Based on Fatigue PerformanceWelding in the World, 2011
- Stress concentrations due to misalignment at butt welds in plated structures and at girth welds in tubularsInternational Journal of Fatigue, 2009
- The Need for a Weld Quality System for Fatigue Loaded StructuresWelding in the World, 2008