A Method for Over-the-Air Noise Figure Measurement of Active Antenna Under Specified Practical Distance
- 6 February 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 74 (00189456) , 1-7
Abstract
This work proposes a noise figure (NF) measurement method for active antennas based on the over-the-air (OTA) method. First, the relevant concepts of NFs are reviewed. Then, the calibration of path gain is proposed and the calculation for the NF is deduced. Finally, the measurement setup and procedure are presented, and the measurements are performed. The results using the proposed method and those from traditional conduction measurement are compared, which verifies our idea. Compared to the existing methods, the proposed method has the advantage of independence on the measurement distance between the transmit antenna and the active antenna under test (AAUT) in a specified range.Keywords
Funding Information
- National Natural Science Foundation of China (62771207)
This publication has 24 references indexed in Scilit:
- Multi-Feed Antenna and Electronics Co-Design: An E-Band Antenna-LNA Front End With On-Antenna Noise-Canceling and Gₘ-BoostingIEEE Journal of Solid-State Circuits, 2020
- OTA G/T Measurements of Active Phased Array Antenna Noise using a Vector Network Analyzer2020
- Phased Arrays for Radio Astronomy, Remote Sensing, and Satellite Communications2018
- Antenna terms and measurement techniques for active receiving arrays2017
- Measuring Noise Temperatures of Phased-Array Antennas for Astronomy at CSIROPublications of the Astronomical Society of Australia, 2014
- IEEE Standard for Definitions of Terms for Antennas2014
- IEEE Standard Definitions of Power Systems Data Transmission and Related Channel Terminology2008
- Microwave Engineering2007
- A Note on a Simple Transmission FormulaProceedings of the IRE, 1946
- Noise Figures of Radio ReceiversProceedings of the IRE, 1944