Erbium-Doped Waveguides Fabricated With Atomic Layer Deposition Method
Authors:
- K. PolamoKPK. Polamo
- 7 January 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 16 (1) , 194-196
Abstract
Atomic layer deposition was used in preparing erbium (Er)-doped waveguides. Ridge-type Er-doped Al/sub 2/O/sub 3/ waveguides were patterned on silica-coated silicon wafers using photolithography and wet etching. Optical absorption, emission, fluorescence lifetime, and signal enhancement measurements were performed. Polarization dependence of the absorption spectrum and birefringence of the waveguide were measured. The material showed strong absorption and wide emission spectrum around 1530 nm with full-width at half-maximum of 52 nm. Signal enhancement of 6 dB was measured for a 3.9-cm-long waveguide.Keywords
This publication has 10 references indexed in Scilit:
- Net gain of 27 dB with a 8.6-cm-long Er/Yb-doped glass-planar-amplifier2002
- Advanced thin films for electronics and opto-electronic's by atomic layer epitaxy2002
- Sol–gel silica/titania-on-silicon Er/Yb-doped waveguides for optical amplification at 1.5 μmOptical Materials, 1999
- Erbium-doped phosphate glass waveguide on silicon with 4.1 dB/cm gain at 1.535 μmApplied Physics Letters, 1997
- Introducing atomic layer epitaxy for the deposition of optical thin filmsThin Solid Films, 1996
- Upconversion in Er-implanted Al2O3 waveguidesJournal of Applied Physics, 1996
- Erbium-doped silica-based waveguide amplifierintegrated with a 980/1530 nm WDM couplerElectronics Letters, 1994
- Erbium-doped phosphosilicate glass waveguide amplifier fabricated by PECVDElectronics Letters, 1993
- Comparison of various polarisation mode dispersion measurement methods in optical fibresElectronics Letters, 1992
- Guided-wave laser based on erbium-doped silica planar lightwave circuitElectronics Letters, 1991