Фазовые равновесия в системе Sn–As–Sb при концентрации олова менее 50 мол.%
Open Access
- 20 March 2020
- journal article
- research article
- Published by Voronezh State University in Kondensirovannye sredy i mezhfaznye granitsy = Condensed Matter and Interphases
- Vol. 22 (1)
Abstract
Tin- and antimony-based alloys, including SnSb and other compounds of the AIVBV type, are used for the production of anodes for Li+- and Na+ion batteries. Multicomponent solid solutions allow varying the properties of the material and improve the technical characteristics of the anodes. There is very little information in the literature about solid phase solubility in the Sn–As–Sb system, and the phase diagram of the system has not been studied yet. The aim of this paper was to study the polythermal sections SnAs–Sb and SnAs–SnSb using the X-ray diffraction analysis (XRD) and differential thermal analysis (DTA), as well as to construct a phase equilibria scheme for the Sn–As–Sb system with the range of tin concentrations of less than 50 mol%. The alloys of the polythermal sections SnAs–Sb and SnAs–SnSb were obtained from pre-synthesized binary compounds and then subjected to homogenizing annealing. The obtained powdered samples were then investigated using differential thermal analysis (DTA) and X-ray diffraction analysis (XRD). The XRD results showed that all the studied alloys were heterophase mixtures of solid solutions (SnAs), (SnSb) and a¢, where a¢ is a solid solution of tin in the As1–xSbx phase. The concentration range of solid solutions based on binary compounds at room temperature was below 10 mol %. The DTA demonstrated that in several alloys of the two sections the fi rst endothermic effect was observed at the same temperature (393±2oС). This temperature corresponds to the peritectic process involving the above-mentioned phases: L + a¢ ↔ (SnAs) + (SnSb). Using the DTA method and the XRD data, Т–х diagrams of polythermal sections SnAs–Sb and SnAs–SnSb were constructed. The coordinates of the invariant peritectic equilibrium L + a¢ ↔ (SnAs) + (SnSb) were determined; a scheme of phase equilibria in the Sn–As–Sb system with the range of tin concentrations of less than 50 mol % was proposed. To construct a complete scheme of phase equilibria in the ternary system, it is necessary to further investigate the SnAs–Sn4Sb3 and Sn4As3–Sn4Sb3 sections. REFERENCESKeywords
This publication has 28 references indexed in Scilit:
- Sn4P3-induced crystalline/amorphous composite structures for enhanced sodium-ion battery anodesJournal of Materials Science & Technology, 2020
- Recent Progress on the Alloy‐Based Anode for Sodium‐Ion Batteries and Potassium‐Ion BatteriesSmall, 2019
- Effect of particle size on the sodium storage performance of Sn4P3Journal of Alloys and Compounds, 2018
- Sn4P3/SbSn Nanocomposites for Anode Application in Sodium‐Ion BatteriesChemElectroChem, 2018
- The phase equilibria in the Sb-Sn system – Part II: Experimental resultsJournal of Alloys and Compounds, 2018
- The phase equilibria in the Sb-Sn system – Part I: Literature reviewJournal of Alloys and Compounds, 2017
- From lithium-ion to sodium-ion batteryRussian Chemical Bulletin, 2017
- Phase equilibria in the Sn–As–Ge and Sn–As–P systemsJournal of Thermal Analysis and Calorimetry, 2014
- Solidification of undercooled Sn-Sb peritectic alloys: Part I. Microstructural evolutionMetallurgical Transactions A, 1991
- The As-Sn (Arsenic-Tin) systemBulletin of Alloy Phase Diagrams, 1990