Field Test Study of Performance of Bored Piles in Collapsible Loess
Open Access
- 8 December 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (24) , 13113
Abstract
Bored piles comprise an advanced pile foundation technology that has the advantages of high bearing capacity, fast construction speed, stable construction technology, and no noise or mud pollution. To study the applicability of bored piles to collapsible loess sites, the compaction effect and load-bearing characteristics of bored piles before and after immersion were studied via a full-scale field test combined with the theory of hole expansion. The results indicate that when the pile spacing is 1.0, 1.25, and 1.5 m, the average dry density of the soil between piles increases by 23.8%, 18.5%, and 3.1%, respectively, compared with that of untreated foundation soil. When bored piles are used to treat deep collapsible loess foundations, the reasonable pile spacing to eliminate the collapsibility of the loess foundation is 2.5 times the pile diameter. It is feasible to estimate the effective compaction range using the pore expansion theory, and the effective compaction coefficients of similar sites are given. The positive friction of bored piles in the collapsible loess area is more than 95.5 kPa, which increases by more than 48.5% compared with that of non-extruded piles. Therefore, the bearing capacity of a single pile is significantly improved, and it is an effective treatment method for collapsible loess areas. Under immersion, the pile side negative friction did not change significantly with a pile diameter of approximately 27 kPa, and the increase was approximately 14% compared with that of non-extruded piles. Consequently, to avoid the adverse effects of negative friction resistance on the bearing capacity of pile foundations and to fully utilize the technical advantages of bored piles, it is necessary to eliminate or partially eliminate site collapsibility before applying bored piles. The results can provide experimental support and theoretical guidance for the popularization and application of screw–squeeze piles in deep, collapsible loess areas.Keywords
Funding Information
- National Natural Science Foundation of China (4236020077, 52268058, 2022054, 22JR5RA369, 21JR7RA306)
- Young Scholars Science Foundation of Lanzhou Jiaotong University (4236020077, 52268058, 2022054, 22JR5RA369, 21JR7RA306)
- Gansu Province Youth Science and Technology Fund program (4236020077, 52268058, 2022054, 22JR5RA369, 21JR7RA306)
- Gansu Province Science and Technology Project Support (4236020077, 52268058, 2022054, 22JR5RA369, 21JR7RA306)
This publication has 14 references indexed in Scilit:
- CHD pile performance: part I – physical modellingProceedings of the Institution of Civil Engineers - Geotechnical Engineering, 2016
- Field Tests to Investigate the Installation Effects of Drilled Displacement Piles with Screw-Shaped Shaft in ClayJournal of Geotechnical and Geoenvironmental Engineering, 2015
- Behavior of Instrumented Omega Pile in Porous SoilAdvanced Materials Research, 2014
- Modeling of Installation and Quantification of Shaft Resistance of Drilled-Displacement Piles in SandInternational Journal of Geomechanics, 2014
- Closure to “Design Methodology for Axially Loaded Auger Cast-in-Place and Drilled Displacement Piles” by Sungwon Park, Lance A. Roberts, and Anil MisraJournal of Geotechnical and Geoenvironmental Engineering, 2013
- Deep Mixing Induced Property Changes in Surrounding Sensitive Marine ClaysJournal of Geotechnical and Geoenvironmental Engineering, 2008
- Advances in Auger Pressure Grouted Piles: Design, Construction and Testing2005
- Practical Considerations in the Selection and use of Continuous Flight Auger and Drilled Displacement Piles2005
- Practical Considerations in the Selection and Use of Continuous Flight Auger and Drilled Displacement Piles2005
- Axial Capacity of Augered Displacement Piles at Auburn University2000