Tuning Parameters of a Ball-Rolling Mill for Rolling of Grinding Balls
- 1 December 2023
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Metallurgy (Metally)
- Vol. 2023 (13) , 2230-2236
Abstract
—For rolling of balls, one of the main parameters for both calculating passes and developing a model for a roll is the roll spacing at the crossing point (zones where the edges of the rolls are as close as possible to each other) in addition to the roll diameter, the roll body length, and the section length. A method is developed to calculate the roll spacing at the crossing point. The calculation results are used to analyze and choose rational tuning parameters of rolls for rolling balls at the EVRAZ NTMK ball-rolling mill. The analysis is carried out on new rolls and rolls after the first, second, third, and fourth remachining of screw ball-rolling grooves. The data are systematized to plot point curves for tuning indicators, and the graphical data are used to make a polynomial approximation. Equations are derived for the functions of the tuning parameters.Keywords
This publication has 8 references indexed in Scilit:
- Computer Simulation of a New Two-Threaded Roll Pass Design for Rolling 100 mm Grinding Balls Made of Alloyed SteelsMetallurgist, 2022
- Improvment of a Double-Helical Roll Pass Design for Rolling 100-mm Grinding BallsMetallurgist, 2022
- Computer Simulation of Double-Threaded Rolling in Production of Grinding Balls with a Diameter of 100 mm from Alloy SteelsMetallurgist, 2022
- Calibration of ball-rolling rollers with continuously variable pitchFerrous Metallurgy. Bulletin of Scientific , Technical and Economic Information, 2018
- Research and industrialization of near-net rolling technology used in shaft partsFrontiers of Mechanical Engineering, 2017
- Set-up of radial–axial ring-rolling process: Process worksheet and ring geometry expansion predictionInternational Journal of Mechanical Sciences, 2015
- Analysis of the Helical-Wedge Rolling Process for Producing a Long Stepped ShaftKey Engineering Materials, 2014
- Designing of screw impressions in the helical rolling of ballsArchives of Civil and Mechanical Engineering, 2014