The Differential Method for Force Measurement Based on Electrostatic Force
Authors:
Open Access
- 1 January 2017
- journal article
- research article
- Published by Wiley in Journal of Sensors
- Vol. 2017, 1-7
Abstract
The small force measurement is very important with development of the technology. The electrostatic force is adopted, in which a pair of coaxial cylindrical capacitors generate the electrostatic force when a voltage is applied across the inner and outer electrodes. However, the measured force will be covered by noise (creep, ground vibration, and air flow) and could not be measured accurately. In this paper, we introduce the differential method to reduce the effect of noise. Two identical parallelogram mechanisms (PM) serve as the mechanical spring. One of the PM serves as the reference and another serves as the force sensor. The common signal will be offset, and the difference signal will serve as output. In this way, the effect of the creep will be reduced. The measurement system of the electrostatic force was characterized by applying mechanical forces of known magnitude via loading weights of calibrated masses. The uncertainty from voltage, laser interferometer, and capacitance gradient was estimated. For the measured force, the relative uncertainty is less than 4% .
Keywords
Funding Information
- Tianjin Natural Science Foundation (17JCYBJC19000, 2011BAK15B06)
- Ministry of Science and Technology of the People’s Republic of China (17JCYBJC19000, 2011BAK15B06)
This publication has 24 references indexed in Scilit:
- Adaptive Fuzzy Sliding Mode Control of MEMS Gyroscope with Finite Time ConvergenceJournal of Sensors, 2016
- Improving environmental noise suppression for micronewton force sensing based on electrostatic by injecting air dampingReview of Scientific Instruments, 2014
- A nanonewton force facility to test Newton's law of gravity at micro‐ and submicrometer distancesAnnalen der Physik, 2013
- Robust Modeling of Low-Cost MEMS Sensor Errors in Mobile Devices Using Fast Orthogonal SearchJournal of Sensors, 2013
- Advances in engineering nanometrology at the National Physical LaboratoryMeasurement Science and Technology, 2012
- Report on the first international comparison of small force facilities: a pilot study at the micronewton levelMetrologia, 2011
- SI traceability: Current status and future trends for forces below 10 microNewtonsMeasurement, 2010
- Facility and methods for the measurement of micro and nano forces in the range below 10−5N with a resolution of 10−12N (development concept)Measurement Science and Technology, 2007
- Recent advances in traceable nanoscale dimension and force metrology in the UKMeasurement Science and Technology, 2006
- Review of SI traceable force metrology for instrumented indentation and atomic force microscopyMeasurement Science and Technology, 2005