Effect of laser powers on the mechanical properties 27SiMn steel with Inconel 718 cladding coatings
Open Access
- 1 September 2022
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (9) , 096511
Abstract
In order to know the influence of laser power on the steel (27SiMn) used for repairing the column with Inconel 718 powder materials, and to obtain the optimal laser power parameters with the best mechanical properties of cladding layer, the microstructure, tensile properties and fracture morphology of the Inconel 718 alloy under three laser powers (1800 W, 2100 W and 2400 W) were investigated by using the single-factor variable method, keeping the scanning speed, powder feeding amount and spot diameter unchanged. The results show that with increase of laser power the mechanical properties of the Inconel 718 alloy coating prepared on the surface for the column steel gradually decreased, and the mechanical properties were the best when the laser power is 1800 W. The yield strength of Inconel 718 alloy coating prepared at 1800 W was 61.7% higher than that of the substrate, and its value is 970 MPa. The elongation is reduced by 50% compared with the substrate, and its value is 7%. The microstructure of 27SiMn steel with cladding coating is (Ni, Fe, Cr) phase and Ni3Fe phase, and the microstructure of the coating is mainly composed of uniform cellular crystals. This study provides a valuable reference for the additive manufacturing of industrial materials of 27SiMn steel with laser-cladding coating.Keywords
This publication has 27 references indexed in Scilit:
- The Experimental Characterization and Numerical Simulation of A-Segregates in 27SiMn SteelMetallurgical and Materials Transactions A, 2017
- Investigations on ultra-high-speed laser material deposition as alternative for hard chrome plating and thermal sprayingJournal of Laser Applications, 2016
- Influence of Nb on the β → α″ martensitic phase transformation and properties of the newly designed Ti–Fe–Nb alloysMaterials Science and Engineering: C, 2016
- Study of process window development for high deposition-rate laser material deposition by using mixed processing parametersJournal of Laser Applications, 2015
- Effect of Fluid Convection on Dendrite Arm Spacing in Laser DepositionMetallurgical and Materials Transactions B, 2014
- Order-sintering of mechanically alloyed FeAl nanostructuresJournal of Alloys and Compounds, 2010
- Evaluation of the volume fraction of nanocrystals devitrified in Al-based amorphous alloysJournal of Non-Crystalline Solids, 2009
- Residual Stress within Metallic Model Made by Selective Laser Melting ProcessCIRP Annals, 2004
- Laser cladding of aerospace materialsJournal of Materials Processing Technology, 2002
- Application of the Hoch-Arpshofen model to the thermodynamics of the Cu-Ni-Sn, Cu-Fe-Ni, Cu-Mg-Al, and Cu-Mg-Zn systemsCalphad, 1987