Indium Oxynitride (InNO) Radiation Sensors Calibration
- 16 February 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 17 (8) , 2372-2376
Abstract
Aerosol effects evaluation on Earth’s radiation budget demands knowledge of its concentration, spatial and temporal distribution. Therefore, long-term measurements of aerosol properties in different regions of Earth are very important. In this work, indium nitride (InN) and indium oxynitride (InNO) based photodiodes calibration was realized. A pyranometer was used in this study. Calibrated InN and InNO Schottky photodiodes will be used for aerosol detection. According to the calibration tests, it was found that the most suitable sensors for the continuation of an aerosol statistical study in the atmosphere are those made with InNO deposited with oxygen 10% and 20%; their correlation coefficient values are almost one. Besides, their measures do not reach the saturation point. In future, we intend to use these devices in a quantitative study of aerosols present in the center of a large city, to get a sense of human interference in the atmosphere composition and its consequences.Keywords
Funding Information
- FAPESP and CNPq
This publication has 6 references indexed in Scilit:
- Optical and electrical properties of sputtered InNO thin filmsphysica status solidi (c), 2012
- Low cost solar irradiation sensor and its thermal behaviourMicroelectronics Journal, 2011
- An extreme change in structural and optical properties of indium oxynitride deposited by reactive gas-timing RF magnetron sputteringApplied Surface Science, 2008
- Local structure of indium oxynitride from x-ray absorption spectroscopyApplied Physics Letters, 2008
- New In O N films for the application in NO2 sensorsSensors and Actuators B: Chemical, 2001
- A sensor element for direct radiation measurementSolar Energy, 1998