Thermal Stress and Cyclic Stress Analysis of a Vertical Water-Cooled Wall at a Utility Boiler under Flexible Operation
Open Access
Abstract
Supercritical once-through utility boilers are increasingly common in flexible operations in China. In this study, the tube temperature changes at a vertical water-cooled wall are analyzed during a fluctuating flexible operation. There are considerable differences in the temperatures of the parallel tubes at the minimum load, and the resulting thermal stress distributions at a front water-cooled wall are established using structural calculation software ANSYS 17.1, USA. A wide thermal stress distribution occurs among the parallel tubes, and the local cyclic stress amplitudes under flexible operation are higher than those under cold, warm, hot, or load-following operations. Because of the water wall expansion structure at the furnace, the higher tube temperature areas suffer from compressive stress, while the lower tube temperature areas suffer from tensile stress. During flexible operation, combustion uniformity and a two-phase flow distribution can improve the safety of vertical water-cooled wall operation. The minimum load of the utility boiler should be set as a limitation, and the tube temperature is an important parameter affecting the thermal and cyclic stresses.Keywords
Funding Information
- Department of Science and Technology, China (2017YFB0602101)
This publication has 7 references indexed in Scilit:
- Mathematical procedure for predicting tube metal temperature in the second stage reheater of the operating flexibly steam boilerApplied Thermal Engineering, 2019
- Online Creep-Fatigue Monitoring of Cyclic Operation in a Coal-Fired Power Plant2017
- Thermal Performance and Stress Monitoring of Power Boiler2016
- Determination of start-up curves for a boiler with natural circulation based on the analysis of stress distribution in critical pressure componentsEnergy, 2015
- Flexibility in 21st Century Power Systems2014
- Failure Analysis2014
- Development of life assessment procedures for power plant headers operated under flexible loading scenariosInternational Journal of Fatigue, 2013