Optimization of a cruciform specimen for fatigue crack growth under in and out-of-phase in-plane biaxial loading conditions
- 21 February 2022
- journal article
- research article
- Published by Taylor & Francis in Mechanics of Advanced Materials and Structures
- Vol. 30 (8) , 1649-1666
Abstract
Mixed-mode loading conditions are present in different mechanical components. Understanding the influence of in-plane biaxial loading paths parameters allows for fatigue crack growth (FCG) prediction and component fatigue life assessment. Cruciform specimens are used to simulate these conditions, but large specimen dimensions are required in order to keep crack propagation unaffected by specimen geometry. This article describes the procedure used to optimize a new cruciform specimen geometry, with small dimensions. Having identified the specimen arms fillet as a major source of crack growth interference, this effect was kept to a minimum, while using arm slots with different widths and lengths. Individual slot dimensions were optimized using a Direct MultiSearch (DMS) algorithm, minimizing the stress intensity factor (SIF) difference between the optimal specimen and an infinite plate. FCG on the optimized specimen was simulated under in and out-of-phase loading conditions. Due to crack closure effects, fatigue propagation under fully out-of-phase loading is less sensitive to specimen geometry. Therefore, the final geometry was chosen considering the required biaxial loading ratio under in-phase loading. HighlightsKeywords
This publication has 65 references indexed in Scilit:
- The numerical simulation of fatigue crack growth using extended finite element methodInternational Journal of Fatigue, 2012
- Fatigue behavior of aluminum alloys under biaxial loadingEngineering Fracture Mechanics, 2011
- Extended finite element method for fretting fatigue crack propagationInternational Journal of Solids and Structures, 2008
- Mixed numerical–experimental technique for orthotropic parameter identification using biaxial tensile tests on cruciform specimensInternational Journal of Solids and Structures, 2007
- Patch repair design optimisation for fracture and fatigue improvements of cracked platesInternational Journal of Solids and Structures, 2007
- Design of a cruciform specimen for biaxial testing of fibre reinforced composite laminatesComposites Science and Technology, 2006
- An interaction integral method for analysis of cracks in orthotropic functionally graded materialsComputational Mechanics, 2003
- Elastic crack growth in finite elements with minimal remeshingInternational Journal for Numerical Methods in Engineering, 1999
- Symmetric Branching of Mode II and Mixed-Mode Fatigue Crack Growth in a Stainless SteelJournal of Engineering Materials and Technology, 1996
- On the Crack Extension in Plates Under Plane Loading and Transverse ShearJournal of Basic Engineering, 1963