Shock Tube and Theory Investigation of Cyclohexane and 1-Hexene Decomposition
- 20 October 2009
- journal article
- research article
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 113 (48) , 13570-13583
Abstract
The decomposition of cyclohexane (c-C6H12) was studied in a shock tube using the laser-schlieren technique over the temperature range 1300−2000 K and for 25−200 Torr in mixtures of 2%, 4%, 10%, and 20% cyclohexane in Kr. Vibrational relaxation of the cyclohexane was also examined in 10 experiments covering 1100−1600 K for pressures below 20 Torr, and relaxation was found to be too fast to allow resolution of incubation times. The dissociation of 1-hexene (1- C6H12), apparently the sole initial product of cyclohexane decomposition, was also studied over 1220−1700 K for 50 and 200 Torr using 2% and 3% 1-hexene in Kr. On heating, cyclohexane simply isomerizes to 1-hexene, and this then dissociates almost entirely by a more rapid C−C scission to allyl and n-propyl radicals. This two-step reaction results in an initial small density gradient from the slight endothermicity of the isomerization. The gradient then rises strongly as the product 1-hexene dissociates. For the lower temperatures, this behavior is fully resolved here. For the higher pressures, 1-hexene decomposition generates negative gradients (exothermic reaction) as the radicals formed begin to recombine. Cyclohexane also generates such gradients, but these are now much smaller because the radical pool is depleted by abstraction from the reactant. A complete mechanism for the 1-hexene decomposition and for that of cyclohexane involving 79 reactions and 30 species is used in the final modeling of the gradients. Rate constants and RRKM fit parameters for the initial reactions are provided for the entire range of conditions. The possibility of direct reaction to allyl and n-propyl radicals, without stabilization of the intermediate 1-hexene, is examined down to pressures as low as 25 Torr, without a clear resolution of the issue. High-pressure limit rate constants from RRKM extrapolation are k∞(c-C6H12 → 1-C6H12) = (8.76 × 1017) exp((−91.94 kcal/mol)/RT) s−1 (T = 1300−2000 K) and k∞(1-C6H12 → •C3H7 + •C3H5) = (1.46 × 1016) exp((−69.12 kcal/mol)/RT) s−1 (T = 1200−1700 K). This high-pressure rate for cyclohexane is entirely consistent with the notion that the isomerization involves initial C−C fission to a diradical. These extrapolated high-pressure rates are in good agreement with much of the literature.Keywords
This publication has 59 references indexed in Scilit:
- Theory, measurements, and modeling of OH and HO2 formation in the reaction of cyclohexyl radicals with O2Physical Chemistry Chemical Physics, 2007
- Combustion Modeling and Kinetic Rate Calculations for a Stoichiometric Cyclohexane Flame. 1. Major Reaction PathwaysThe Journal of Physical Chemistry A, 2007
- Detailed Chemical Kinetic Modeling of Cyclohexane Oxidation†The Journal of Physical Chemistry A, 2007
- Ab initio evaluation of primary cyclo-hexane oxidation reaction ratesProceedings of the Combustion Institute, 2007
- Benzene precursors and formation routes in a stoichiometric cyclohexane flameProceedings of the Combustion Institute, 2007
- Kinetics of 1-hexene oxidation in a JSR and a shock tube: Experimental and modeling studyCombustion and Flame, 2006
- Experimental and modeling study of 1-hexene oxidation behind reflected shock wavesProceedings of the Combustion Institute, 2005
- Gas-Phase Combustion Chemistry2000
- Survey of recent cyclohexane pyrolysis literature and stoichiometric analysis of cyclohexane decompositionIndustrial & Engineering Chemistry Research, 1991
- Chemical Kinetics and Combustion ModelingAnnual Review of Physical Chemistry, 1990