Characterization of CRM Binders with Wax Additives Using an Atomic Force Microscopy (AFM) and an Optical Microscopy
Authors:
- 1 July 2017
- journal article
- research article
- Published by ASTM International in Advances in Civil Engineering Materials
- Vol. 6 (1) , 504-525
Abstract
This paper investigates the change in micromorphology of two binders and their respective warm mix asphalt binders before and after aging using atomic force microscopy (AFM) and optical microscopy. The control (PG 64-22) and crumb rubber modified (CRM) binders were blended with two different types of wax additives (L, a wax-based composition including crystal controller, and S, a long chain aliphatic hydrocarbon) and then artificially short-term and long-term aged using the rolling thin film oven and pressure aging vessel procedures. L is a wax based composition including crystal controller and S is a long chain aliphatic hydrocarbon. The AFM tapping-mode imaging technique was used to analyze the microstructure and the Superpave asphalt binder test was used to measure the rheology properties. In general, the results of this study indicated that (1) a correlation was observed between the changes in micromorphology (the distribution of dispersed domains and matrix) and rheology properties regardless of the aging, binder, and wax types; (2) the addition of crumb rubber into the base binder decreased the dimension of the catana phase (“bee-like”) structure, which increased the quantity of these structures; (3) the opposite trend was found between the aged control binder and the aged CRM binder regarding the size of the bee-like structure; (4) the long-term aging seemed to have a significant effect on the microstructures of the warm control and CRM binders; and (5) the inclusion of S and L was observed to have a similar trend for both binder types in terms of increased size of the bee-like structure and no bee-like structure, respectively.Keywords
This publication has 50 references indexed in Scilit:
- Performance of Warm Mix Asphalt containing Sasobit®: State-of-the-artConstruction and Building Materials, 2013
- Laboratory evaluation on high temperature viscosity and low temperature stiffness of asphalt binder with high percent scrap tire rubberConstruction and Building Materials, 2012
- Effects of liquid antistrip additives on rheology and moisture susceptibility of water bearing warm mixturesConstruction and Building Materials, 2010
- On the existence of wax-induced phase separation in bitumenInternational Journal of Pavement Engineering, 2010
- Microstructure and performance of crumb rubber modified asphaltConstruction and Building Materials, 2009
- Fatigue behavior of rubberized asphalt concrete mixtures containing warm asphalt additivesConstruction and Building Materials, 2009
- Particle Size Effect of Crumb Rubber on Rheology and Morphology of Asphalt Binders with Long-term AgingRoad Materials and Pavement Design, 2008
- Polymer modified asphalt bindersConstruction and Building Materials, 2007
- Comparative Laboratory Study of Sasobit and Aspha-Min Additives in Warm-Mix AsphaltTransportation Research Record: Journal of the Transportation Research Board, 2007
- Louisiana Experience with Crumb Rubber-Modified Hot-Mix Asphalt PavementTransportation Research Record: Journal of the Transportation Research Board, 2002