Design and Optimization of Manufacturing Process of Polymer Composites Through Multiscale Cure Analysis and NSGA-II
- 3 November 2023
- journal article
- research article
- Published by Springer Nature in Integrating Materials and Manufacturing Innovation
- Vol. 12 (4) , 321-337
Abstract
No abstract availableKeywords
This publication has 37 references indexed in Scilit:
- Inverse heat transfer for optimization and on-line thermal properties estimation in composites curingInverse Problems in Science and Engineering, 2004
- Spring-in and warpage of angled composite laminatesComposites Science and Technology, 2002
- A fast and elitist multiobjective genetic algorithm: NSGA-IIIEEE Transactions on Evolutionary Computation, 2002
- Experimental and numerical study of the effect of cure cycle, tool surface, geometry, and lay-up on the dimensional fidelity of autoclave-processed composite partsComposites Part A: Applied Science and Manufacturing, 2002
- OPTIMIZED CURING OF THICK SECTION COMPOSITE LAMINATESMaterials and Manufacturing Processes, 2001
- A Plane Strain Model for Process-Induced Deformation of Laminated Composite StructuresJournal of Composite Materials, 2001
- Spring-in study of the aileron rib manufactured from advanced thermoplastic compositeComposites Part A: Applied Science and Manufacturing, 1998
- Process-Induced Stress and Deformation in Thick-Section Thermoset Composite LaminatesJournal of Composite Materials, 1992
- Process Modeling of Composite Materials: Residual Stress Development during Cure. Part II. Experimental ValidationJournal of Composite Materials, 1992
- Thermoset characterization for moldability analysisPolymer Engineering & Science, 1974