Characterization of the Structural and Tribological Properties of Medical Ti6Al4V Alloy Produced in Different Production Parameters Using Selective Laser Melting
Authors:
- 1 October 2019
- journal article
- research article
- Published by SAGE Publications in 3D Printing and Additive Manufacturing
- Vol. 6 (5) , 253-261
Abstract
The tribological properties of the parts produced by the selective laser melting (SLM) are greatly influenced by the parameters/strategies used in the production and the postproduction heat treatments. Therefore, it is very important to know and control the parameters to be used in production on the tribological properties of the material. In this study, the effects of build orientation, hatch spacing, and heat treatment on the wear performance of medical Ti6Al4V alloy were investigated. The tribological properties of the samples produced by SLM were compared with the tribological characteristics of the parts produced by conventional method (casting). It was determined that the wear resistance of Ti6Al4V alloy increased with the decreasing of hatch spacing in SLM and the wear resistance of the 45° angle on the production table positively affected the relative density rate. The highest surface hardness among the samples was obtained as ∼360 HV0.3 for the sample produced at the 60 μm hatch spacing and 45° build orientation, which was the highest densification rate obtained. The lowest wear rate value was obtained for the sample produced at 60 μm hatch spacing and 45° build orientation where the highest densification rate and highest surface hardness were obtained. The wear rate of this sample was 26% lower than the wear rate of the sample produced by the casting method. The most suitable build orientation was determined as 45° in terms of wear resistance of the alloy.Keywords
This publication has 15 references indexed in Scilit:
- Recent developments and opportunities in additive manufacturing of titanium-based matrix composites: A reviewInternational Journal of Machine Tools and Manufacture, 2018
- Effect of process parameters on tribological performance of 316L stainless steel parts fabricated by selective laser meltingManufacturing Letters, 2018
- Wear behavior of Ti6Al4V biomedical alloys processed by selective laser melting, hot pressing and conventional castingTransactions of Nonferrous Metals Society of China, 2017
- Nanoindentation and wear properties of Ti and Ti-TiB composite materials produced by selective laser meltingMaterials Science and Engineering: A, 2017
- Sliding wear of selective laser melting processed Ti6Al4V under boundary lubrication conditionsWear, 2016
- Tribology of selective laser melting processed parts: Stainless steel 316 L under lubricated conditionsWear, 2016
- Manufacture by selective laser melting and mechanical behavior of commercially pure titaniumMaterials Science and Engineering: A, 2014
- Sliding Wear Characteristics and Corrosion Behaviour of Selective Laser Melted 316L Stainless SteelJournal of Materials Engineering and Performance, 2013
- Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titaniumActa Materialia, 2012
- Wear Performance of SLS/SLM MaterialsAdvanced Engineering Materials, 2008