The Mechanical Harvesting of Hemp Using In-Field Stand-Retting: A Simpler Approach Converted to the Production of Fibers for Industrial Use
Open Access
- 22 October 2020
- journal article
- research article
- Published by MDPI AG in Sustainability
- Vol. 12 (21) , 8795
Abstract
The mechanical harvesting of hemp is a key step toward a profitable use of the product. Various fractions (fiber, seeds, residual biomass) may be recovered, and their correct management is fundamental for complying with the requirements of processors/end users. In the light of the renewed interest for its industrial use (panels and insulators), this work proposes the use of modified commercial machines to implement a field separation of the fibrous fraction of stand-retted hemp, a practice that would be profitable if realized with the systems adopted for textile use. The present work was conducted to test the efficiency of harvesting partially macerated plants by using a modified self-propelled forage harvester (SPFH). In Northern Italy, a hemp crop was stand-retted for four months. Then, an SPFH—with rotor knives reduced in number from 24 to 12—was used. Stand-retting made it possible to separate cortical fibers from the inner stem cylinder during harvesting; 53.3% of the material (fibers and shives) was separated automatically by the SPFH together with the chopped bast fiber, while the remaining 46.7% was separated on exiting the launch tube. More than 50% of the fibers were shorter than 5 cm in length, while almost 15% were longer than 10 cm. The SPFH had an effective operating speed of 3.48 km h−1, and no clogging occurred during the test. Therefore, the combination of stand-retting with harvesting using a modified SPFH could be helpful in obtaining an early separation of fibers from shives, thus facilitating the product treatment during its subsequent processing, e.g., by enhancing the defibration.Keywords
Funding Information
- Italian Ministry of Agriculture, food and forestry MIPPAF - AGROENER project ((D.D. no. 26329, 1st April 2016, http://agroener.crea.gov.it/ ))
This publication has 28 references indexed in Scilit:
- Effect of harvest time and field retting duration on the chemical composition, morphology and mechanical properties of hemp fibersIndustrial Crops and Products, 2015
- Harvesting strategies of bast fiber crops in Europe and in ChinaIndustrial Crops and Products, 2015
- Analysis of the hemp fiber mechanical properties and their scattering (Fedora 17)Industrial Crops and Products, 2013
- Prototype for the harvesting of cultivated herbaceous energy crops, an economic and technical evaluationBiomass and Bioenergy, 2013
- Effect of different extraction methods on fiber quality of nettle (Urtica dioica L.)Textile Research Journal, 2010
- Industrial Applications of Natural Gas2010
- Effect of variety, seed rate and time of cutting on fibre yield of dew-retted hempIndustrial Crops and Products, 2006
- Hemp Production in ItalyJournal of Industrial Hemp, 2005
- Hemp as a raw material for industrial applicationsEuphytica, 2004
- Quality Aspects in Hemp Fibre Production—Influence of Cultivation, Harvesting and RettingJournal of Industrial Hemp, 2003