Antioxidative copper sinter bonding under thermal aging utilizing reduction of cuprous oxide nanoparticles by polyethylene glycol
Authors:
Open Access
- 19 October 2023
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science
- Vol. 58 (40) , 15617-15633
Abstract
Durability of sintered Cu joints under thermal aging in the air was investigated for the reduction of Cu2O using Cu2O/polyethylene glycol (PEG) mixture. Thermal analysis of the Cu2O/PEG paste showed that the molecular weight of PEG influences the redox reaction and the subsequent bonding related to the combustion of the reducing organic solvent. Sintered Cu joints using PEG 400 exhibited high joint strength (above 30 MPa) in shear tests, even for the bonding temperature of 280 °C. The sintered Cu joints exhibited slightly increased strength during thermal aging at 250 °C in air, which was also confirmed by the microscale tensile test used for evaluating the fracture behavior of the sintered Cu structure. Microstructural analysis, including the evaluation of the crystal orientation, revealed a small change in the microstructure of sintered joints during aging. Transmission electron microscopy revealed the presence of organic membranes on slightly oxidized sintered Cu grains before thermal aging, and additional oxidation was observed after thermal aging. The progress of sintering during thermal aging in vacuum was different than that in air. It was considered that the formation of a thin Cu2O layer, controlled by the presence of organic membranes, contributed to the suppression of Cu sintering. Graphical abstractKeywords
Funding Information
- Japan Society for the Promotion of Science (22H01832)
- Osaka University
This publication has 47 references indexed in Scilit:
- A long-term oxidation barrier for copper nanowires: graphene says yesPhysical Chemistry Chemical Physics, 2015
- A comparative study of the morphology and wetting characteristics of micro/nanostructured Cu surfaces for phase change heat transfer applicationsJournal of Adhesion Science and Technology, 2013
- Copper Can Still Be Epitaxially Deposited on Palladium Nanocrystals To Generate Core–Shell Nanocubes Despite Their Large Lattice MismatchACS Nano, 2012
- Aminoclay: a permselective matrix to stabilize copper nanoparticlesChemical Communications, 2009
- A novel metal-to-metal bonding process through in-situ formation of Ag nanoparticles using Ag2O microparticlesJournal of Physics: Conference Series, 2009
- Thermomechanical Reliability of Low-Temperature Sintered Silver Die Attached SiC Power Device AssemblyIEEE Transactions on Device and Materials Reliability, 2006
- Metal–metal bonding process using Ag metallo-organic nanoparticlesActa Materialia, 2005
- Thermodynamics and Densification Kinetics in Solid-state Sintering of CeramicsJournal of Materials Research, 1999
- Wide bandgap semiconductor materials for high temperature electronicsThin Solid Films, 1999
- Effects of oxidation and surface roughness on contact angleExperimental Thermal and Fluid Science, 1994