The Stratigraphic Organization of Incised-Valley Systems Associated with Relative Sea-Level Change

Authors:

Abstract
The most common form of incised-valley system develops during a lowering in base level associated with a fall in relative sea level. This form of incised-valley system provides the most complete, and at times, the only evidence of lowstand to early-transgressive deposition in shelf and/or shallow ramp depositional settings. Incised-valley systems of this type are characterized by a flu-vially-eroded, elongate paleotopographic low, generally larger than a single channel, which displays an abrupt basinward shift of facies at its base. The valley fill typically begins to accumulate during base-level rise, and may contain deposits of the following highstand and subsequent sea-level cycles. Two major varieties of incised valley occur during a lowering of sea level: (i) incised-valley systems that have their headwaters in a (mountainous) hinterland and cross a "fall line" (or knickpoint) are here considered to be piedmont incised-valley systems, and (ii) incised-valley systems that are localized within low-gradient coastal plains and that do not cross a "fall line" are here termed coastal-plain incised-valley systems. An incised-valley system that is filled during one depositional sequence is termed a simple fill, whereas a compound fill records multiple cycles of incision and deposition. The fill of an incised-valley system that forms in response to a lowering of base level is divisible into three segments: (i) the seaward reaches of the incised valley (SEGMENT 1) is characterized by backstepping (lowstand to transgressive) fluvial and estuarine deposits, overlain by transgressive marine sands and shelf muds; (ii) the middle reach of the incised valley (SEGMENT 2) consists of the drowned-valley estuarine complex that is developed at the time of maximum transgression, overlying a lowstand to transgressive succession of fluvial and estuarine deposits like those in segment 1; and (iii) the innermost reach of the incised valley (SEGMENT 3) lies headward of the transgressive estuarine limit, and extends to the point where changes in relative sea level no longer control fluvial style. Segment 3 is characterized by fluvial deposits throughout its depositional history; however, the fluvial style may change systematically due to changes in base level and the rate of creation of accommodation space. The stratigraphic organization of these incised-valley systems is characterized by a number of stratigraphically-significant surfaces that differ greatly in their origin, geographic extent, and chronostratigraphic significance. Filling of the valley may begin during the lowstand, but typically continues through the succeeding transgression. Thus, the transgressive surface (i.e., the flooding surface separating the Lowstand Systems Tract and the Transgressive Systems Tract) should be present in the lower portion of the fill. It may occur within fluvial deposits or at the fluvial-estuarine contact in segments 1 and 2, and at a correlative change in fluvial depositional style in segment 3. Erosion by tidal currents in tidal inlets or other tidal channels creates a tidal ravinement surface which is confined to the incised valley in segment 1 and the seaward part of segment 2. More regional erosion by waves at the retreating shoreface produces a wave ravinement surface that separates fluvial and/or estuarine sediments from overlying marine deposits in segment 1. Both of these surfaces are diachronous, and could become amalgamated with the sequence boundary. In the idealized case, a maximum flooding surface may extend throughout the incised-valley fill, passing from its typical position within marine shales in segment 1, through the center of the estuarine deposits in segment 2, into fluvial sediments in segment 3. However, rapid relative sea-level fall after the end of the transgression, or renewed sea-level rise after valley filling (but before the onset of significant progradation), may prevent development of the maximum flooding surface. Compound valley fills may contain multiple sets of these surfaces.