A new insert drawing technique for controlling ore loss and dilution during sublevel caving
Authors:
Open Access
- 2 July 2025
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-15
Abstract
Sublevel caving (SLC) is widely used in underground mines for its low cost and high production rate, but it faces challenges such as high ore loss and dilution. The previous research has focused on shape of draw bodies, stope structural parameters of SLC and drawing management. However, the flow of waste rocks, ore-rock contact and its control in the drawing process are not deeply studied. This study analyzed the main causes of these issues and the formation mechanism of waste rock funnels, proposing the insert drawing method (IDM) to reduce ore loss and dilution. This technique involves actively controlling the contact, movement direction, and path of ore-rock near the drawpoints using an insert device. By manipulating insert device, the technique effectively enhances ore flow velocity and area, resulting in enhanced ore recovery. By managing the movement of waste rock funnel, the technique can delay dilution entry in the drawpoints, effectively reducing ore dilution. Further, to validate IDM’s effectiveness, comparative experiments were conducted between IDM and traditional cut-off grade drawing method (COGDM). The experimental results indicate that IDM outperforms COGDM in terms of ore recovery rate. For the mining of massive orebodies with SLC, IDM achieves a 10.96% higher ore recovery rate compared to COGDM; for steeply inclined medium-thick orebodies, IDM’s ore recovery rate surpasses COGDM by 15.68–30.88%. The research demonstrates that IDM effectively reduces ore loss and dilution in SLC, making it suitable for widespread application in other SLC mines.Keywords
Funding Information
- National Natural Science Foundation of China (51574151)
This publication has 21 references indexed in Scilit:
- A new diversion drawing technique for controlling ore loss and dilution during longitudinal sublevel cavingInternational Journal of Rock Mechanics and Mining Sciences, 2019
- A Study of Gravity Flow Based on the Upside-Down Drop Shape Theory and Considering Rock Shape and BreakageRock Mechanics and Rock Engineering, 2018
- Orthogonal Simulation Experiment for Flow Characteristics of Ore in Ore Drawing and Influencing Factors in a Single Funnel Under a Flexible Isolation LayerJOM, 2017
- Confirmation of the upside-down drop shape theory in gravity flow and development of a new empirical equation to calculate the shapeInternational Journal of Rock Mechanics and Mining Sciences, 2017
- Parameters influencing full scale sublevel caving material recovery at the Ridgeway gold mineInternational Journal of Rock Mechanics and Mining Sciences, 2010
- Study of multiple draw-zone interaction in block caving mines by means of a large 3D physical modelInternational Journal of Rock Mechanics and Mining Sciences, 2008
- A study of isolated draw zones in block caving mines by means of a large 3D physical modelInternational Journal of Rock Mechanics and Mining Sciences, 2007
- Modeling of Area-End Ore Drawing under Caved RocksJournal of Mining Science, 2005
- Sublevel cavingInternational Journal of Rock Mechanics and Mining Sciences, 1966
- Gravity flow of granular materials in Hoppers and bins in mines—II. Coarse materialInternational Journal of Rock Mechanics and Mining Sciences, 1965