Influence of Physical and Mechanical Properties of the Substrate on the Behavior of Zr–Si–B Coatings under Sliding Friction and Cyclic Impact-Dynamic Loading
- 1 September 2020
- journal article
- research article
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 56 (5) , 981-989
Abstract
The method of magnetron sputtering of a ZrB2–20% Si target was used to obtain coatings on substrates of molybdenum, chromium, and hard alloy. The composition, structure and tribological properties of the coatings have been studied. The influence of physical and mechanical properties of substrates on the behavior of coatings under friction sliding and impact of impact dynamic loading is established. The coating had a low-defect structure and contained a hexagonal ZrB2 phase with a crystallite size of 15–30 nm. Tribological tests of the substrates showed that, at a load of 1 N, the friction coefficient was in the range of 0.6–0.8. After coating, this value was 0.7–0.75. When using a hard alloy as a substrate in the tribocontact zone, brittle destruction of the coating was observed at the lowest penetration depth of the counterbody. In the case of coatings on substrates with low hardness and modulus of elasticity, the maximum wear depth was reached, there was a pronounced deformation, and the portion of the plastic component was reduced after coating. The resistance of substrates to impact dynamic loading at 100, 300, and 500 N regularly increased with an increase in their hardness and plasticity index. The coating obtained on a carbide substrate with a hardness of 19 GPa and a plasticity index of 0.03 showed a crater depth of 0.45 μm, which is 16 and 5 times less than for coatings on molybdenum and chromium alloys.Keywords
This publication has 29 references indexed in Scilit:
- Influence of the ZrB2 content on the anti-oxidation ability of ZrB2-SiC coatings in aerobic environments with broad temperature rangeJournal of the European Ceramic Society, 2020
- Anti-oxidation modification behaviors and mechanisms of ZrB2 phase on Si-based ceramic coatings in aerobic environment with wider temperature regionJournal of Alloys and Compounds, 2018
- The ablation behavior of ZrB2-SiC coating prepared by shrouded plasma spray on SiC-coated graphiteJournal of Alloys and Compounds, 2018
- Comparative investigation of structure, mechanical properties, and oxidation resistance of Mo-Si-B and Mo-Al-Si-B coatingsCorrosion Science, 2017
- High-temperature nanoindentation of epitaxial ZrB2 thin filmsScripta Materialia, 2016
- A Comparative Study of Spray-dried and Mechanically-mixed ZrB2-MoSi2 Composite Coatings Fabricated by Low Pressure Plasma SprayRare Metal Materials and Engineering, 2016
- Hard and elastic epitaxial ZrB2 thin films on Al2O3(0001) substrates deposited by magnetron sputtering from a ZrB2 compound targetActa Materialia, 2016
- Effect of Si addition on the microstructure, mechanical properties and tribological properties of Zr–Si–N nanocomposite coatings deposited by a hybrid coating systemSurface and Coatings Technology, 2014
- A SiC–Si–ZrB2 multiphase oxidation protective ceramic coating for SiC-coated carbon/carbon compositesCeramics International, 2012
- The behaviour of ZrB x (0 ≤x ≤ 2) thin films deposited on si substrate as a function of annealing treatmentJournal of Electronic Materials, 1989